Specifications
Product type | LCD Projector |
Model |
|
Video system | PAL/SECAM/NTSC 3.58/NTSC 4.43/DTV 480P/DTV 720P/DTV 1080I |
Display method | LCD panel 3, RGB optical shutter method |
LCD panel | Panel size: 0.9 (13.9 [H] 18.5 [W] mm) |
| Display method: Translucent TN liquid crystal panel |
| Drive method: TFT (Thin Film Transistor) Active Matrix panel |
Lens | No. of dots: 786,432 dots (1,024 [H] 768 [V]) |
Projection lamp | DC 200 W lamp |
Contrast ratio | 250:1 |
Video input signal | RCA Connector: VIDEO, composite video, 1.0 |
RCA Connector: AUDIO, 0.5 Vrms more than 22 kΩ (stereo) | |
| Y (luminance signal): 1.0 |
C(chrominance signal): Burst 0.286
Audio output 3 W (monaural)
Computer RGB input signal | |
| RGB separate/composite sync/sync on green type analog input: |
| 75 Ω terminated |
| STEREO MINIJACK: AUDIO, 0.5 Vrms, more than 22 kΩ (stereo) |
| HORIZONTAL SYNC. SIGNAL: TTL level (positive/negative) or composite sync (Apple only) |
| VERTICAL SYNC. SIGNAL: Same as above |
Pixel clock | |
Vertical frequency | |
Horizontal frequency | |
Computer control signal | |
Speaker system | 3 3⁄32 (8 cm) round |
Rated voltage | AC |
Input current | 3.3 A |
Rated frequency | 50/60 Hz |
Power consumption | 300 W |
Standby power consumption | 4.7 W (AC120V) |
Power dissipation | < 1,130 BTU/hour |
Operating temperature | 41°F to 104°F (5°C to 40°C) |
Storage temperature | 4°F to 140°F (20°C to 60°C) |
Cabinet | Plastic |
I/R carrier frequency | 38 kHz |
Laser pointer of remote control | Wave length: 650 nm / Max. output: 1 mW / Class II Laser Product |
Dimensions (approx.) | 9 1⁄64 (W) 4 49⁄64 (H) 12 13⁄64 (D) (229 121 310 mm) (main body only) |
| 9 19⁄32 (W) 5 9⁄32 (H) 14 7⁄64 (D) (243.5 134 358.4 mm) (including |
| adjustment feet and projecting parts) |
Weight (approx.) | 10.6 lbs. (4.8 kg) |
Supplied accessories | Remote control, Two AA size batteries, Power cord (11 10, 3.6 m), Computer RGB cable |
| (9 10, 3 m), Computer audio cable (9 10, 3 m), USB mouse control cable (3 33, 1 m), |
| |
| cap (attached), |
| Sharp Advanced Presentation Software operation manual |
Replacement parts | Lamp unit (Lamp/cage module) |
| AA size batteries, Power cord (CACCU0106DE01), Computer RGB cable |
| (QCNWG0002CEZZ), Computer audio cable |
| cable (QCNWG0007CEPZ), |
| mouse receiver (RUNTK0673CEZZ), Air filter (PFILD0076CEZZ), Lens cap |
| (GCOVH1307CESB), |
| |
| Presentation Software operation manual |
This SHARP projector uses LCD (Liquid Crystal Display) panels. These | This unit has some inactive TFTs within acceptable tolerances which | ||
very sophisticated panels contain 786,432 pixels ( RGB) TFTs (Thin | may result in illuminated or inactive dots on the picture screen. This | ||
Film Transistors). As with any high technology electronic equipment | will not affect the picture quality or the life expectancy of the unit. | ||
such as large screen TVs, video systems and video cameras, there | If you have any questions about this matter, please call toll free | ||
are certain acceptable tolerances that the equipment must conform | U.S.A. ONLY |
| |
to. |
|
|
|
Specifications are subject to change without notice. | Appendix |
|