Runco VX-5000d, VX-4000d manual DHD Controller Front Panel

Controls and Functions

Figure 2-4shows the controls and indicators on the DHD Controller front panel; the paragraphs that follow describe them.

2.3

DHD Controller Front Panel

1 2 3 4 5 6 7 8 9 10

Figure 2-4. DHD Controller Front Panel

1.RUNCO ICON

Lights red to indicate that the DHD Controller is in standby mode; lights blue to indicate that the unit is on.

2.POWER BUTTON

Press once to toggle from standby mode to on mode. Press it again to return to standby mode. For a discrete on or off command, you can use the direct access buttons on the remote control.

3.IR SENSOR

Receives IR commands from the remote.

4.VACUUM FLUORESCENT DISPLAY

Can be used instead of the On-Screen Display (OSD). Displays currently-selected menu or -- if no menu is selected -- the current source, signal format (NTSC or PAL), input resolution and aspect ratio.

5.UP BUTTON

Used to direct select aspect ratios or move the menu cursor up in the On-Screen Display. When no menus are present on-screen, the UP button toggles you through aspect ratios in the following order:

Anamorphic - Standard (4:3) - Letterbox - VirtualWide - Cinema - Virtualwide 2.35

(Virtualwide 2.35 is available only on CineWide-equipped projectors. For more information about aspect ratios, refer to Table 4-1.)

6.LEFT BUTTON

Used to direct select inputs or move the menu cursor left in the On-Screen Display. When no menu is present on-screen, the LEFT button toggles you through the different sources, in this order:

HD Pass Thru 2 - HD Pass Thru 1 - DVI 2 - DVI 1 - HD/RGB 2 - HD/RGB1 - Component SD - S-Video 2 - S-Video 1 - Composite

7.ENTER BUTTON

Press ENTER to select a highlighted menu item.

Runco VX-4000d/VX-5000d Owner’s Operating Manual 9