Runco VX-4000d, VX-5000d manual RS-232 Controller, Connection

Installation

RS-232 Controller	➤	Use a standard, 9-pin RS-232 cable to connect a PC or home theater control/automation
Connection		system (if present) to the RS-232 Control port on the DHD Controller; see Figure 3-12.
		For more information about using this connection, refer to Serial Communications on
		page 61.
		5	4	3	2	1

			TRIGGERS
		1	2	3	IR
Pb	Pr	Y	S-Video 1
	Component Video	Video	S-Video 2	RS-232 Out	RS-232 Control

9 8 7 6

2 Transmit Data

3 Receive Data

5 Ground

(none of the other pins are used)

	to Automation/
	Control System
	or PC
	Figure 3-12. RS-232 Control System Connection
Connecting 12-Volt ➤	If your VX-4000d/VX-5000d is equipped with a CineWide with AutoScope system, or if
Trigger Outputs to	your home theater contains other devices that respond to 12-volt triggers (such as
External Theater	retractable screens or screen masks), connect them to the 12-volt trigger outputs as
Components	shown in Figure 3-13.
			TRIGGERS
		1	2	3	IR
	Pb Pr	Y	S-Video 1
	Component Video	Video	S-Video 2	RS-232 Out	RS-232 Control
					3.5-mm
					mini plug

to CineWide with AutoScope system or other home theater components (screen, screen mask etc.)

Figure 3-13. Connecting 12-Volt Trigger Outputs

34 Runco VX-4000d/VX-5000d Owner’s Operating Manual