Runco VX-5000d, VX-4000d manual Main Menu, Input Source, Aspect Ratio, HD Pass Thru 1 HD Pass Thru

Operation

The Main Menu is the starting point for accessing all projector functions.

(The Calibration and Service menus are hidden and not accessible until you enter a passcode.)

Main Menu

Runco Video

Input Source

Aspect Ratio

Picture

Input Position

ISF Presets

Information

Calibration

Service

From the Main Menu, select Input Source to choose a video signal source.

The active source is indicated by an arrow (>) to its left; in the example at right, Composite is the active source.

1. Selecting HD Pass Thru 1 or HD Pass Thru 2 loops the

Note HD/RGB 1 or HD/RGB 2 input signal respectively to the RGB output. This prevents display of the on-screen menus. To switch from HD Pass Thru 1 or 2 to another source, use the direct access buttons on the remote control, or the left- or right-arrow buttons on the DHD Controller.

2.If the DVI 1 or DVI 2 input is active and the input signal is HDCP-encrypted, the RGBHV output of the DHD Controller is disabled.

To change the aspect ratio (size and shape) of the projected image, select Aspect Ratio from the Main Menu and press ENTER. Select the appropriate aspect ratio for your screen size and the type of program material being viewed; refer to Table 4-1.

The currently-selected aspect ratio is indicated by a “7” to its left; in the example at right, Anamorphic is selected.

When you change the aspect ratio, save the change to a preset

Note afterwards. Otherwise, the change will be lost when a different input is selected. (The aspect ratio is saved for each input and

resolution separately.) For information about saving settings, refer to ISF Presets on page 48.

Input Source

Input Source

>Composite S-Video 1 S-Video 2 Component SD HD/RGB 1 HD/RGB 2 DVI 1

DVI 2

HD Pass Thru 1 HD Pass Thru 2

Aspect Ratio

Aspect Ratio

7Anamorphic

…Standard 4:3

…Letterbox

…VirtualWide

…Cinema

…Virtualwide 2.35

Runco VX-4000d/VX-5000d Owner’s Operating Manual 41