Runco VX-5000d, VX-4000d manual Installation, Operation

3. Installation

		3.1
		Remote Control
To install batteries in the remote control:		Battery Installation
1. Remove the battery cover from	Touch-Screen Remote	Standard DHD Remote
the back of the remote control.

2. Insert the batteries included with the remote control. Ensure that the polarities correctly match the and markings inside the battery compartment.

3. Replace the battery cover.

With the touch-screen remote: After a few seconds, the remote starts up automatically and an Introduction screen appears.

The remote control beeps twice to indicate that it has started up successfully.

1.	Do not mix an old battery with a new one or different types of
Note	batteries.
2.	If you will not use the remote control for a long time, remove the
	batteries to avoid damage from battery leakage.
The remote control can be used to control the VX-4000d/VX-5000d within the ranges		Notes on Remote Control
shown in Figure 3-1.		Operation

Approx.Approx.

30m/100ft7m/23ft

Figure 3-1.Available Range of the Remote Control

Runco VX-4000d/VX-5000d Owner’s Operating Manual 19