Sim2 Multimedia HT300 XTRA installation manual DVI Input

XTRA

Only horizontal scanning frequencies of 15 kHz (standard vi- deo resolution) or 32 kHz (high definition video, with progressi- ve scanning) can be applied to this input.

DVI INPUT

A DVI-D signal (digital RGB) can be applied to this input (Fig. 21).

DVI

C-SYNC

CAUTION: This is not a VESA “Plug & Display” connector. Never connect a computer to this socket as the projector and the computer may be damaged (Fig. 23).

Fig. 21

REMOTE INPUT INTERFACE CONNECTING CABLE

Fig. 23

MOTORISED PROJECTION SCREEN OUTPUT

With a special cable (optional), it is possible to connect the Remote Input Interface (optional) to the projector(Fig. 22).

DVI

C-SYNC

Fig. 22

Connect/disconnect the special Remote Input Interface cable only when the projector is switched off and disconnected from the mains (switch in position O).

12

Fig. 24

The projector is equipped with two outputs (Voltage: 12 Vdc) for motorised projection screen and screen masking systems. These 12V outputs should be connected to the appropriate screen interface provided by the screen manufacturer (Fig. 24).

The +12V output is activated when the projector is switched on (green LED on) and is de-activated when the projector is in stand-by mode (red LED on).