Motorola WA840G manual Mm .3 inches maximum 10.5 mm .4 inches maximum

Page 23

SECTION 2

INSTALLATION

 

 

8If necessary, seat an anchor in each hole. Use M5 x 38 mm (#10-16 x 1½ inch) screws with a flat underside and maximum screw head diameter of 10.5 mm to mount the access point.

9Using a screwdriver, turn each screw until part of it protrudes from the wall, as shown:

!There must be 4.0 mm (.16 inches) between the wall and the underside of the screw head.

!The maximum distance from the wall to the top of the screw head is 7.6 mm (.3 in).

7.6mm (.3 inches) maximum

10.5mm (.4 inches) maximum

4.0 mm

10Remove the front two plastic feet, nearest to the LED panel, from the bottom of the access point to uncover the keyholes.

11Place the access point so the keyholes are above the mounting screws.

12Slide the access point down until it stops against the top of the keyhole opening.

13Follow the installation procedures for connecting and configuring the access point.

2-6

WA840G

Image 23
Contents User Guide Wireless Access Point FCC Compliance Class B Digital Device Canadian Compliance Contents Glossary Overview Secure Transmission Wireless ConnectivityOverview Overview Section FeaturesUnderstanding Your User Guide Wireless Connections Box ContentsTCP/IP Closed Area Positioning Your Access PointWireless Range Data Rate Open AreaTechnical Specifications Type of Networks Access Point ModeWDS Access Point Mode Feature Description Access Point Physical DescriptionBack of Access Point Front of Access Point None LED DescriptionLED Condition Color StatusAntenna Installation Hardware SetupAccess Point Physical Installation InstallationVertical Installation Installation Section80.00mm Installation Section Mm .3 inches maximum 10.5 mm .4 inches maximum Easy Software Setup Electrical Connection to Access PointWired Connection to Access Point Manual Software SetupWireless Connection to Access Point Not using Dhcp Continue to use the Static IP settings Configure Your ComputersSelect Settings Control Panel Configuring Windows 98SE and MEInstallation Configuring Windows Ensure the box next to Internet Protocol TCP/IP is selected Installation Section Configuring Windows XP Installation Section Installation Logging Configure Your Wireless Security SettingsSelect Control Panel Device Security Wireless Security SetupSelect to Wireless Basic Navigate to Wireless SecurityUsing the Web-Based Configuration Utility ConfigurationFor convenience, it is recommended that you finish ConfigurationNavigation Help, Restart, and LogoutField or Button Description Configuration SectionConfiguring Wireless Network Settings Basic Wireless ConfigurationConfiguration FieldDescription Configuring Wireless Security SettingsField Description Extended Service Set ESS . AuthenticationTkip is recommended for home users. If If you are using other non-Motorola wireless Field Configuration Configuration Section Monitoring Wireless Access Points Site Survey Field Description Station Association ListAdvanced Wireless Configuration Configuration Auto Mbps DefaultDisable AllConfiguring Control Panel Settings Dhcp Configuring Network AddressConfiguring Device Security Updating Firmware Defaults Saving and Restoring Configuration SettingsContact Hardware SolutionsTroubleshooting Start button to ProgramsAccessoriesCommand Prompt Troubleshooting SectionSoftware Solutions Cannot access the Configuration Utility for the access point Troubleshooting Section Troubleshooting Ascii Dhcp GlossaryBSS CPEDsss Glossary SectionDNS DSLGUI ESSFTP Ieee HexadecimalHost IcmpMTU IsdnISP LANPing NATNIC PcmciaROM PPPPptp Smtp RTSUDP TCPTCP/IP WAP USBVPN WANWWW WlanWPA Mgbi