Andis Company P333T-PWR quick start Building a stack, Tip

Page 10

Before you Start

Building a stack

Follow the guidelines in this section in order to build a working stack using any combination of the following devices:

●P330 series

●P330-ML series

●G700

●P330 series

1. Add only a single box at a time to an existing stack.

! Important:

The stack master (also called "stack IP Agent") may fail to preserve existing "stack configuration" if you will add more than a single device to an existing stack at a time.

-After adding the first box, wait until the stack is functioning fully before adding the next device.

2.Refer to Table 4 to see which firmware versions can be used in mixed stacks.

For example, if you wish to add a P332G-ML to a stack with P330 4.5 switches, the P332G-ML switch must have firmware version 4.5.8.

-Upgrade/downgrade the firmware of switches that do not match version in the table.

Tip:

It is highly recommended to upgrade/downgrade before connecting the added box to an existing stack.

-Ensure switches of the same type have the same firmware version

8 Quick Start for Hardware Installation: P333T-PWR Stackable Switch

Image 10

Contents Quick Start for Hardware Installation Avaya P333T-PWR Stackable SwitchPage Contents Page Page Nm 860 nm DBm Nm 1360 nm Nm 1570 nm Gathering Information Defining the InstallationBefore you Start Preparing Contacts you might needChoosing the Installation Site Preparing Installation FilesPreparing Needed Tools Power Requirements Environmental Requirements Condition Acceptable valuesBuilding a stack TipStack without C360 Stack with C360 Switch C363T-PWR C364T-PWRStack Master election rules C364T-PWR Page Unpack the Device EquipmentDocumentation Avaya P330 Documentation and Utilities CD Page Mount the Device Closed hinged endOpen hinged end Power Up AC inputDC input optional P333R DC version rear panelPrepare for Configuration Establishing a Console ConnectionAssigning a Stack IP Address Configuring the Switch Establishing a Telnet ConnectionAvaya P333R Default Settings Basic configurationAssigning the Stack IP Address Default Switch Settings Function Default Setting Default Port Settings Parameter Default Setting Overview Device ManagerSystem Requirements Order to Use the following command Configuring the Device ManagerDevice Manager Commands Running the Device ManagerWelcome Installing the Java Plug-in Installing from the P330 Documentation and Utilities CDInstall from the Avaya Web Site Install from your Local Web SiteDocumentation