Andis Company P333T-PWR quick start Establishing a Telnet Connection, Configuring the Switch

Page 25

Establishing a Telnet Connection

-At the prompt, type set ip route <dest> <gateway> and replace <dest> and <gateway> with the destination and gateway IP addresses.

Establishing a Telnet Connection

Perform the following steps to establish a Telnet connection to the P333T-PWR for configuration of Stack or Router parameters. You can Telnet the Stack Master IP address:

1.Connect your station to the network.

2.Verify that you can communicate with the Avaya P333T-PWR by pinging the IP of the Avaya P333T-PWR. If there is no response using ping, check the IP address and default gateway of both the Avaya P333T-PWR and the station.

Tip:

The Avaya P333T-PWR default IP address is 149.49.32.134 and the default subnet mask is 255.255.255.0.

3.From the Microsoft Windows taskbar of your PC click Start and then Run (or from the DOS prompt of your PC), then start the Telnet session by typing: telnet

<P333R_IP_address>

For example: telnet 149.49.32.134

4.If the IP Address in the Telnet command is the IP address of the stack, then connection is established with the Switch CLI entity of the Master module.

●The “Welcome to P333T-PWR screen appears

5.Enter the default name root at the Login name prompt.

6.Enter the User Level password root in lower case letters (do not use uppercase letters) at the Password prompt.

●The User level prompt will appear when you have established communications with the Avaya P333T-PWR

You can now configure the stack and change its IP address.

Configuring the Switch

This section describes the procedures for the first-time configuration of the Avaya P333T-PWR The factory defaults are set out in detail in the tables included in this chapter.

You may configure the Avaya P333T-PWR using the text-based Command Line Interface (CLI), the built-in Device Manager or Avaya Integrated Management.

Issue 1 September 2005 23

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Avaya P333T-PWR Stackable Switch Quick Start for Hardware InstallationPage Contents Page Page Nm 860 nm DBm Nm 1360 nm Nm 1570 nm Before you Start Defining the InstallationGathering Information Preparing Contacts you might needChoosing the Installation Site Preparing Installation FilesPreparing Needed Tools Environmental Requirements Condition Acceptable values Power RequirementsTip Building a stackC363T-PWR C364T-PWR Stack without C360 Stack with C360 SwitchStack Master election rules C364T-PWR Page Equipment Unpack the DeviceDocumentation Avaya P330 Documentation and Utilities CD Page Closed hinged end Mount the DeviceOpen hinged end AC input Power UpP333R DC version rear panel DC input optionalEstablishing a Console Connection Prepare for ConfigurationAssigning a Stack IP Address Establishing a Telnet Connection Configuring the SwitchAvaya P333R Default Settings Basic configurationAssigning the Stack IP Address Default Switch Settings Function Default Setting Default Port Settings Parameter Default Setting Overview Device ManagerSystem Requirements Device Manager Commands Configuring the Device ManagerOrder to Use the following command Running the Device ManagerWelcome Installing from the P330 Documentation and Utilities CD Installing the Java Plug-inInstall from your Local Web Site Install from the Avaya Web SiteDocumentation
Top Page Image Contents