Andis Company P333T-PWR quick start Prepare for Configuration, Establishing a Console Connection

Page 23

Chapter 5: Prepare for Configuration

This chapter provides information on preparing the P333R for configuration, and discusses the following topics:

●Establishing a Console Connection

●Assigning a Stack IP Address

●Establishing a Telnet Connection

●Configuring the Switch

Establishing a Console Connection

This section describes the procedure for establishing switch access between a terminal and the Avaya P333T-PWR switch over the serial port provided on the front panel of the P333T-PWR (RJ-45 connector labeled “Console”). For information on the console port pin assignments, refer to the Avaya P333T-PWR User Guide.

Figure 6: Avaya P333T-PWR Console Port

1

Figure notes:

1.Console port

1.Use the serial cable supplied to attach the RJ-45 console connector to the Console port of the active switch. Connect the DB-9 connector to the serial (COM) port on your PC/ terminal.

- The master switch is indicated by the SYS LED being ON.

2.Ensure that the serial port settings on the terminal are:

Issue 1 September 2005 21

Image 23

Contents Avaya P333T-PWR Stackable Switch Quick Start for Hardware InstallationPage Contents Page Page Nm 860 nm DBm Nm 1360 nm Nm 1570 nm Preparing Contacts you might need Defining the InstallationBefore you Start Gathering InformationPreparing Needed Tools Preparing Installation FilesChoosing the Installation Site Environmental Requirements Condition Acceptable values Power RequirementsTip Building a stackC363T-PWR C364T-PWR Stack without C360 Stack with C360 SwitchStack Master election rules C364T-PWR Page Equipment Unpack the DeviceDocumentation Avaya P330 Documentation and Utilities CD Page Closed hinged end Mount the DeviceOpen hinged end AC input Power UpP333R DC version rear panel DC input optionalEstablishing a Console Connection Prepare for ConfigurationAssigning a Stack IP Address Establishing a Telnet Connection Configuring the SwitchAssigning the Stack IP Address Basic configurationAvaya P333R Default Settings Default Switch Settings Function Default Setting Default Port Settings Parameter Default Setting System Requirements Device ManagerOverview Running the Device Manager Configuring the Device ManagerDevice Manager Commands Order to Use the following commandWelcome Installing from the P330 Documentation and Utilities CD Installing the Java Plug-inInstall from your Local Web Site Install from the Avaya Web SiteDocumentation