Andis Company P333T-PWR quick start Mount the Device, Closed hinged end

Chapter 3: Mount the Device

You can mount the P333T-PWR in a rack.

The P333T-PWR chassis fits in most standard 19-inch racks. It is 2U (3.5”, 88 mm) high.

Before you Install the P333T-PWR in a Rack

●Disconnect all cables from the unit before proceeding with the rack installation.

●When installing the P333T-PWR in a rack, ensure that the equipment is positioned such that it will not cause the rack to become unstable or tip over.

●Ensure that the combination of equipment in the rack will not cause an overload or overcurrent condition on the power strip being used and/or the customer's branch circuit.

●The P333T-PWR units weigh a maximum of 15 pounds (6.8 kg). Be careful when installing or removing the P333T-PWR product from the rack.

●If a power strip is being used in the rack, ensure that it has a reliable earth connection. If the P333T-PWR equipment will be plugged directly into a wall outlet, ensure that there is a reliable ground connection at the outlet.

●Ensure that the internal rack ambient temperature is within the operating specification limits of the P333T-PWR.

●Ventilation for the P333T-PWR is from side to side. Ensure that there is adequate space on each side of the P333T-PWR equipment when installed in the rack to allow sufficient airflow.

Place the P333T-PWR in the rack as follows:

1.Snap open the hinged ends of the unit’s front panel to reveal the screw holes. Refer to Figure 2 and Figure 3.

Figure 2: Closed hinged end

P333R

51	52	53	54	55	56	57	58	1	2	3	4	5	6	7	8	9	10	11 12
EXPANSION
SLOT			62							15		17						23	24
59	60	61		63 64		65	66	13	14		16		18	19 20		21 22
				FIV			LNK COL	Tx	Rx	FDX	FC Hspd	LAG					ROUTSYS	OPR	PWR
																					LAG				LAG				LAG
																			1	2	3	4	5	6	7	8	9	10	11	12
																														CONSOLE
1																			13	14	15	16	17	18	19	20	21	22	23	24

Figure notes:

1.Closed hinged end

Issue 1 September 2005 17