Andis Company P333T-PWR quick start Device Manager, Overview, System Requirements

Page 29

Chapter 6: Device Manager

This chapter describes the installation procedures for the Device Manager.

Overview

The Device Manager provides the following:

●Managing and monitoring Power over Ethernet.

●Device Configuration - Viewing and modifying the different device configurations.

●Virtual LANs - Viewing and editing Virtual LAN information.

●Link Aggregation Groups (LAGs) - Viewing and editing LAG information.

●Port Redundancy - Setting port redundancy for ports in a P333T-PWR Switch.

●Port Mirroring - Setting up port mirroring for ports in a P333T-PWR Switch.

●Trap Managers Configuration - Viewing and modifying the Trap Managers Table.

●Switch Connected Addresses - View devices connected to selected ports.

●Port Security.

●Intermodule Redundancy

●One pair per stack.

●Also operates as a result of a module fault, for example, power failure.

System Requirements

Minimum hardware and operating system requirements are:

●Pentium II 400 Mhz-based computer with 128 Mb of RAM.

●Screen resolution of 1024 x 768 pixels.

●Microsoft Internet Explorer 5 or higher.

●Microsoft Windows 2000 Workstation or Windows XP.

Issue 1 September 2005 27

Image 29

Contents Avaya P333T-PWR Stackable Switch Quick Start for Hardware InstallationPage Contents Page Page Nm 860 nm DBm Nm 1360 nm Nm 1570 nm Before you Start Defining the InstallationGathering Information Preparing Contacts you might needPreparing Needed Tools Preparing Installation FilesChoosing the Installation Site Environmental Requirements Condition Acceptable values Power RequirementsTip Building a stackC363T-PWR C364T-PWR Stack without C360 Stack with C360 SwitchStack Master election rules C364T-PWR Page Equipment Unpack the DeviceDocumentation Avaya P330 Documentation and Utilities CD Page Closed hinged end Mount the DeviceOpen hinged end AC input Power UpP333R DC version rear panel DC input optionalEstablishing a Console Connection Prepare for ConfigurationAssigning a Stack IP Address Establishing a Telnet Connection Configuring the SwitchAssigning the Stack IP Address Basic configurationAvaya P333R Default Settings Default Switch Settings Function Default Setting Default Port Settings Parameter Default Setting System Requirements Device ManagerOverview Device Manager Commands Configuring the Device ManagerOrder to Use the following command Running the Device ManagerWelcome Installing from the P330 Documentation and Utilities CD Installing the Java Plug-inInstall from your Local Web Site Install from the Avaya Web SiteDocumentation