Jumper and Switch Settings
CAN Enable Switch (SW2)
The Controller Area Network (CAN) enable switch (SW2) disconnects CAN signals from the GPIO pins of the processor. When the SW2 switch is in the OFF position, the associated GPIO signals (see Table
Table
CAN Signal | SW2 Switch Position (Default) | Processor Signal | |
|
|
|
|
|
|
|
|
ENABLE | 1 | (ON) | NU |
|
|
|
|
STANDBY | 2 | (ON) | NU |
|
|
|
|
ERROR | 3 | (ON) | PD9 |
|
|
|
|
RECEIVE DATA | 4 | (ON) | PC1 |
|
|
|
|
UART Enable Switch (SW4)
The UART enable switch (SW4) disconnects UART signals from the GPIO pins of the processor. When the switch is in the OFF position, the associ- ated GPIO signals (see Table
Table
SW4 Switch Position (Default) | Processor Signal | ||
|
|
|
|
|
|
|
|
CTS | 1 | (ON) | PC0 |
|
|
|
|
RX0 | 2 | (ON) | NU |
|
|
|
|
RTS | 3 | (ON) | PC1 |
|
|
|
|
LOOPBACK | 4 | (OFF) | NU |
|
|
|
|