AMX NXB-KNX manual Port Settings

Page 13

	Configuration
Domain Suffix:	Enter the Domain Suffix for this unit.
DNS 1, 2, 3:	Enter up to three DNS addresses for this unit.
Reboot:	Click to initiate a system reboot. IP Settings changes only take effect after a
	reboot.

Port Settings

Select Port Settings from the Admin drop-down menu to open the Port Settings page (FIG. 7). Use the options on the page to specify various Port settings for this NXB-KNX unit.

FIG. 7 Port Settings page

The options on this page provide inputs for enabling and disabling of HTTP, HTTPS, Telnet, SSH and FTP ports, and allow you to change each port number from it’s standard default assignment.

HTTP Port Number:	Default = enabled, default port number = 80.
HTTPS Port Number:	Default = enabled, default port number = 443.
Telnet Port Number:	Default = enabled, default port number = 23.
SSH Port Number:	Default = enabled, default port number = 22.
FTP Port Number:	Default = enabled, default port number = 21.
Restore Factory Defaults:	Click to restore all Port settings to the factory defaults.
Reboot:	Click to initiate a system reboot. Port changes only take effect after a
	reboot.

NXB-KNX NetLinx KNX Interface	9

Image 13

Contents NXB-KNX AMX Limited Warranty and Disclaimer Table of Contents Table of Contents NXB-KNX NetLinx KNX Interface Overview Product SpecificationsIntended for indoor use only Wiring and Connections InstallationEthernet 10/100 Base-T RJ-45 Wiring Configuration PoE Power Over Ethernet KNX ConnectorBonjour Zero-Configuration Client ConfigurationOverview Determining the IP Address of the NXB-KNXAccessing the WebConsole Admin MenuEnable / Disable Security Settings Security SettingsLogin Information Logging Into the Configuration Manager With Security Enabled IP SettingsPort Settings Port SettingsClock Manager Clock Manager Mode ManagerClock Manager Daylight Savings Manager Clock Manager Daylight SavingsOnly one Nist server is selectable at any given time Clock Manager Nist ServersCurrent Application Information Application UpgradeBrowse for new Application Upload File Current Firmware Information Firmware UpgradeBrowse for new Firmware Upload File Establishing a Terminal Connection Via Telnet Programming Telnet CommandsTerminal Commands Security Setup RebootMEM MSG OnoffSET DNS SET Ethernet Mode CMDSET Java Heap SET FTP PortSET IP SET Https PortSET LOG Count SET SSH PortSET Time SET Telnet PortShow LOG Show LOG ALLShow MEM Show HeapTime Programming Telnet Commands NXB-KNX NetLinx KNX Interface Programming Telnet Commands NXB-KNX NetLinx KNX Interface It’s Your World Take Control