AMX NXB-KNX manual Installation, Wiring and Connections

Page 7

Installation

Installation

Wiring and Connections

To avoid any damage to the electronic component, installation must be performed in an ESD safe environment.

Do not connect power to the NXB-KNX until the wiring is complete.

The NXB-KNX is installed between the NetLinx Master and the KNX control bus, and passes NetLinx control commands to the KNX control bus via 2-wire twisted pair cabling, as indicated in FIG. 1:

 

 

 

NetLinx Master

 

NXB-KNX

 

 

 

PoE injector

KNX

Control

Bus

Ethernet 10/100

2-wire twisted pair

FIG. 1 NXB-KNX installation

After you have completed the installation, consult the Configuration section on page 5.

Ethernet 10/100 Base-T RJ-45 Wiring Configuration

The table below describes the pinouts, signals, and pairing for the Ethernet 10/100 Base-T connector and cable.

Ethernet Pinouts and Signals

Pin

Signals

Connections

Pairing

Color

1

TX +

1 ---------

1

1 ---------

2

White-Orange

2

TX -

2 ---------

2

 

 

Orange

3

RX +

3 ---------

3

3 ---------

6

White-Green

4

no connection

4 ---------

4

 

 

Blue

5

no connection

5 ---------

5

 

 

White-Blue

6

RX -

6 ---------

6

 

 

Green

7

no connection

7 ---------

7

 

 

White-Brown

8

no connection

8 ---------

8

 

 

Brown

FIG. 2 diagrams the RJ-45 pinouts and signals for the Ethernet RJ-45 connector and cable.

FIG. 2 Straight-Through Wiring

 

NXB-KNX NetLinx KNX Interface

3

Image 7
Contents NXB-KNX AMX Limited Warranty and Disclaimer Table of Contents Table of Contents NXB-KNX NetLinx KNX Interface Overview Product SpecificationsIntended for indoor use only Wiring and Connections InstallationEthernet 10/100 Base-T RJ-45 Wiring Configuration PoE Power Over Ethernet KNX ConnectorDetermining the IP Address of the NXB-KNX ConfigurationBonjour Zero-Configuration Client OverviewAccessing the WebConsole Admin MenuEnable / Disable Security Settings Security SettingsLogin Information Logging Into the Configuration Manager With Security Enabled IP SettingsPort Settings Port SettingsClock Manager Clock Manager Mode ManagerClock Manager Daylight Savings Manager Clock Manager Daylight SavingsOnly one Nist server is selectable at any given time Clock Manager Nist ServersCurrent Application Information Application UpgradeBrowse for new Application Upload File Current Firmware Information Firmware UpgradeBrowse for new Firmware Upload File Establishing a Terminal Connection Via Telnet Programming Telnet CommandsTerminal Commands MSG Onoff RebootSecurity Setup MEMSET FTP Port SET Ethernet Mode CMDSET DNS SET Java HeapSET SSH Port SET Https PortSET IP SET LOG CountShow LOG ALL SET Telnet PortSET Time Show LOGShow MEM Show HeapTime Programming Telnet Commands NXB-KNX NetLinx KNX Interface Programming Telnet Commands NXB-KNX NetLinx KNX Interface It’s Your World Take Control