AMX NXB-KNX manual KNX Connector, PoE Power Over Ethernet

Page 8

Installation

PoE (Power Over Ethernet)

The NXB-KNX uses CAT5/CAT6 wire via the Ethernet port for PoE power.

Use the PS-POE-AF Power over Ethernet Injector (FG423-80) to simplify wiring and installation by eliminating the need for an AC outlet at each point of installation.

The NXB-KNX can be placed up to approximately 330’ (100 meters) from PoE

Injector.

If used with a non PoE-capable Ethernet switch (such as the NXA-ENET24), then an optional PS- POE-AF Power-over-Ethernet (PoE) power supply is required to provide power to the NXB-KNX.

If the NXB-KNX is used with a PoE-capable Ethernet switch (such as the NXA-ENET24PoE), then no PoE Injectors are required.

KNX Connector

The KNX connector on the rear panel is a 2-pin captive-wire connector that provides communication between the NXB-KNX and the KNX control system via 2-wire shielded twisted pair cabling (FIG. 3).

-+

KNX

Control

Bus

2-wire twisted pair

FIG. 3 KNX Connector wiring diagram

4

NXB-KNX NetLinx KNX Interface

Image 8
Contents NXB-KNX AMX Limited Warranty and Disclaimer Table of Contents Table of Contents NXB-KNX NetLinx KNX Interface Product Specifications OverviewIntended for indoor use only Ethernet 10/100 Base-T RJ-45 Wiring Configuration InstallationWiring and Connections KNX Connector PoE Power Over EthernetConfiguration Bonjour Zero-Configuration ClientOverview Determining the IP Address of the NXB-KNXAdmin Menu Accessing the WebConsoleLogin Information Security SettingsEnable / Disable Security Settings IP Settings Logging Into the Configuration Manager With Security EnabledPort Settings Port SettingsClock Manager Mode Manager Clock ManagerClock Manager Daylight Savings Clock Manager Daylight Savings ManagerClock Manager Nist Servers Only one Nist server is selectable at any given timeBrowse for new Application Upload File Application UpgradeCurrent Application Information Browse for new Firmware Upload File Firmware UpgradeCurrent Firmware Information Programming Telnet Commands Establishing a Terminal Connection Via TelnetTerminal Commands Reboot Security SetupMEM MSG OnoffSET Ethernet Mode CMD SET DNSSET Java Heap SET FTP PortSET Https Port SET IPSET LOG Count SET SSH PortSET Telnet Port SET TimeShow LOG Show LOG ALLTime Show HeapShow MEM Programming Telnet Commands NXB-KNX NetLinx KNX Interface Programming Telnet Commands NXB-KNX NetLinx KNX Interface It’s Your World Take Control