AMX NXB-KNX manual Clock Manager Daylight Savings Manager

Configuration

Re Sync Period: Select the desired re-synch period for the clock from this drop-down menu. Re- synch period options include 5 minutes, 15 minutes, 1, 2 and 4 hours (default = 1 hour).

Timezone: Select the appropriate Time Zone from the drop-down menu.

Date:Use these fields to manually enter today’s date (mm/dd/yyyy).

Time: Manually enter the current time (hh:mm:ss).

Click Accept to save your changes. Note that changes on this page take effect immediately.

Click Cancel to cancel any changes.

Clock Manager - Daylight Savings

Select Daylight Savings from the Clock Manager sub-menu (or from the main Clock Manager page), and the Daylight Savings Manager page will be displayed (FIG. 11):

FIG. 11 Clock Manager - Daylight Savings Manager page

Note that this tab is enabled only if Network Time is selected (on the Mode Manager page).

The options on this page allow you to enable and disable daylight savings, and specify daylight savings start and end times.

Daylight Savings: Use these radio buttons to turn daylight savings time on and off (default = Off).

Offset:Use these drop-down menus to specify the amount of time to offset the clock for daylight savings.

Starts:These options allow you to specify when to start using daylight savings time. Select a month and time to start from the drop-down menus.

•Select Fixed to start daylight savings at a specific Day, Month and Time (an additional field for Day is provided when this radio button is selected).

•Select Occurrence to start daylight savings at a specified occurrence (additional fields for Week of the Month, and Day of the Week are provided).

NXB-KNX NetLinx KNX Interface 11