AMX NXB-KNX manual SET Https Port, Set Ip, SET LOG Count, SET SSH Port

Programming - Telnet Commands

Terminal Commands (Cont.)

CommandDescription

SET HTTPS PORT	Sets the NXB-KNX’s IP port listened to for HTTPS connections.
	Note: The NXB-KNX must be rebooted to enable new settings.
	Example:
	>SET HTTPS PORT
	Current HTTPS port number = 443
	Enter new HTTPS port number (Usually 443) (0=disable HTTPS):
	Once you enter a value and press the ENTER key, you get the follow-
	ing message:
	Setting HTTPS port number to
	New HTTPS port number set, reboot the NXB-KNX for the change
	to take affect.
SET IP	Sets the IP configuration.
	Enter a Host Name, Type (DHCP or Fixed), IP Address, Subnet Mask,
	and Gateway IP Address.
	Note: For NetLinx Central Controllers, the "Host Name" can only
	consist of alphanumeric characters.
	• Enter Y (yes) to approve/store the information into the NXB-KNX.
	• Enter N (no) to cancel the operation.
	Note: The NXB-KNX must be rebooted to enable new settings.
	Example:
	>SET IP
	--- Enter New Values or just hit Enter to keep current settings ---
	Enter Host Name:	MLK_INSTRUCTOR
	Enter IP type. Type D for DHCP or S for Static IP and then Enter:
	DHCP
	Enter Gateway IP:	192.168.21.2
	You have entered: Host Name		MLK_INSTRUCTOR
		Type	DHCP
		Gateway IP	192.168.21.2
	Is this correct? Type Y or N and Enter -> y
	Settings written. Device must be rebooted to enable new settings.
SET LOG COUNT	Sets the number of entries allowed in the message log.
	Note: The NXB-KNX must be rebooted to enable new settings.
	Example:
	>SET LOG COUNT
	Current log count = 1000
	Enter new log count (between 50-10000):
	Once you enter a value and press the ENTER key, you get the follow-
	ing message:
	Setting log count to
	New log count set, reboot the NXB-KNX for the
	change to take affect.
SET SSH PORT	Sets the NXB-KNX’s IP port listened to for SSH connections.
	Note: The NXB-KNX must be rebooted to enable new settings.
	Example:
	>SET SSH PORT
	Current SSH port number = 22
	Enter new SSH port number (Usually 22) (0=disable SSH):
	Once you enter a value and press the ENTER key, you get the follow-
	ing message:
	Setting SSH port number to 22
	New SSH port number set, reboot the NXB-KNX for
	the change to take affect.

NXB-KNX NetLinx KNX Interface 19