D-Link DSL-G604T Telnet Status, Telnet TCP Port, Number, Web Status, Link Aggregation Algorithm

	DGS-3024 Gigabit Ethernet Switch Manual
	IP router. The default is Disabled.
Telnet Status	This indicates if a Telnet connection is currently enabled on the Switch. The default is
	Enabled.
Telnet TCP Port	The TCP port number. TCP ports are numbered between 1 and 65535. The "well-
Number (1-65535)	known" TCP port for the Telnet protocol is 23.
Web Status	Web-based management is Enabled by default. If you choose to disable this by select-
	ing Disabled, you will lose the ability to configure the system through the web interface
	as soon as these settings are applied

Web TCP Port Number (1-65535)

RMON Status

GVRP

The TCP port number currently being utilized by the Switch to connect to the web interface. The "well-known" TCP port for the Web interface is 80.

This indicates if RMON is enabled on the Switch. The default is Disabled.

This indicates if Group VLAN Registration Protocol (GVRP) is enabled on the Switch. GVRP is a protocol that allows members to dynamically join VLANs. The Switch’s GVRP settings can be changed on the GVRP Settings window (Configuration → VLANs → 802.1Q Port Settings). The default is Disabled.

Link Aggregation Algorithm

The algorithm that the Switch uses to balance the load across the ports that make up the port trunk group is defined by this definition. Choose MAC Source, MAC Destination, or MAC Src & Dest, (For further information, see the Link Aggregation section, under the Link Aggregation folder).

Switch 802.1x	The Switch’s 802.1x function may be enabled by port; the default is Disabled. This field
	must be enabled to view and configure certain windows for 802.1x. More information
	regarding 802.1x, its functions and implementation can be found later in this section,
	under the Port Access Entity folder. Port-Based 802.1x specifies that ports configured
	for 802.1x are initialized based on the port number only and are subject to any
	authorization parameters configured.
Syslog State	This allows you to enable or disable the System Log State. The default is Disabled.

25