D-Link DSL-G604T manual Parameter Description Group ID, State, Type

DGS-3024 Gigabit Ethernet Switch Manual

To configure port trunking, click on the Link Aggregation hyperlink in the Configuration folder to bring up the following window:

Figure 7- 7. Port Trunking Group window

To configure port trunk groups, click the Add button to add a new trunk group and use the Port Trunking Configuration window to set up trunk groups. To modify a port trunk group, click the Modify button corresponding to the entry you wish

to alter. To delete a port trunk group, click the corresponding under the Delete heading in the Current Trunking Group Entries table.

Figure 7- 8. Port Trunking Configuration window

The user-changeable parameters are as follows:

Parameter	Description
Group ID [1-4]		Select an ID number for the group, between 1 and 4.
State		Trunk groups can be toggled between Enabled and Disabled. This is used to turn a
		port trunking group on or off. This is useful for diagnostics, to quickly isolate a
		bandwidth intensive network device or to have an absolute backup aggregation
		group that is not under automatic control.
Type		The type of port trunking supported by the DGS-3024 is Static.

30