American Power Conversion AP9615 manual Shut down and power off the connected, Equipment, Panel

Page 10

Installing the Hub

 

continued

 

 

 

Installation

Matrix-UPS™

procedure,

a

Shut down and power off the connected

continued

 

equipment.

 

 

b

Turn off the circuit breaker on the bottom left

 

 

 

side on the back panel of the UPS.

 

 

Symmetra™ Power Array™

 

 

a

Shut down and power off the connected

 

 

 

equipment.

 

 

b

Turn off the System Enable switch on the

 

 

 

bottom left side on the back panel of the UPS.

 

 

Smart-UPS®DP

 

 

a

Shut down and power off the connected

 

 

 

equipment.

 

 

b

Turn off the ON/OFF switch on the front

 

 

 

panel.

 

 

Triple Chassis for Silcon DP300E Series UPSs

 

 

a

Shut down and power off the connected equip-

 

 

 

ment.

 

 

b

If present, unplug the Triple Chassis’s power

 

 

 

supply from the AC power outlet.

 

 

c

Disconnect the cable attached to the To UPS

 

 

 

port on the Triple Chassis.

2 Unpack the 5 Port 10Base-T Hub. The shipping materials are recyclable. Please save, reuse, or dis- pose of them appropriately.

Handle the 5 Port 10Base-T Hub by the front panel. Do not touch the exposed printed cir- cuit board or components. Touching the circuit board or components may result in damage to the hub.

Continued on next page

6

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Port 10Base-T Hub Thank You Contents Page Introduction SmartSlot 5-Port 10Base-T Hub is an APC accessoryLAN by installing it in the SmartSlot of an APC UPS or That allows you to expand or create a local area networkProduct Description For a description of the conditions indicated by LEDs Label Color Activity DescriptionWays, as shown in Figure Munication cable for each device to be attachedInstalling the Hub Turn off the ON/OFF switch on the front Shut down and power off the connectedTurn off the System Enable switch on If present, unplug the Triple Chassis’s powerBack panel of the UPS or triple chassis. Keep Use a #2 Phillips head screwdriver to removeScrews fastening the SmartSlot cover plate to Screws for below. Save the SmartSlot coverPlug the UPS back into the AC power outlet Using straight-through UTP cables, connect the StaProcedure listed below Press and hold the Power On button until youInstallation Procedure Use of a crossover cable to connect the Uplink ports As many as 32 stations, as shown below in . Note2 central hubs Removing the Hub Provides suggestions for troubleshooting your hub TroubleshootingAction Cause Solution Troubleshooting Suggestions Specifications Port 10Base-T HubWarranty Information Technician will help solve the problem over ProcedureBe prepared to provide a description of the problem Authorization RMA numberConformity is Application of CouncilDirectives Standards to Which DeclaredW. a p c c . c o m
Top Page Image Contents