American Power Conversion AP9615 manual Product Description

Page 6

Product Description

Front panel	This figure shows the front panel of the 5 Port 10Base-T Hub.
	The features of the front panel are described in the paragraphs
	that follow.

APC Communications

Compatibility Number

Collision LED	Uplink port

Station ports

Power LED

15

Link/Traffic					Partition
	1X	2X	3X	4X	Uplink

Col

Pwr

www. apcc . com

Smart Slot

AP9615 5 Port 10Base-T Hub

Link/Traffic LED

Partition LED

Figure 1: Front Panel and Connector Detail

APC

The APC Communications Compatibility Number (CCN),

Communications

which appears on the upper left corner of the front panel,

Compatibility

refers to the ability of an accessory to work with other APC

Number

products. (The CCN for your hub may be different from the

example shown in Figure 1.) In general, we strive to make all

APC products compatible with one another; however, if you

want specific information on the compatibility of the 5 Port

10Base-T Hub with APC UPSs and accessories, visit the

APC support page (http://www.apcc.com/support/#kbase)

and search for Communications Compatibility Number.

Continued on next page

2

Image 6

Contents Port 10Base-T Hub Thank You Contents Page Introduction SmartSlot 5-Port 10Base-T Hub is an APC accessoryLAN by installing it in the SmartSlot of an APC UPS or That allows you to expand or create a local area networkProduct Description For a description of the conditions indicated by LEDs Label Color Activity DescriptionWays, as shown in Figure Munication cable for each device to be attachedInstalling the Hub Turn off the ON/OFF switch on the front Shut down and power off the connectedTurn off the System Enable switch on If present, unplug the Triple Chassis’s powerBack panel of the UPS or triple chassis. Keep Use a #2 Phillips head screwdriver to removeScrews fastening the SmartSlot cover plate to Screws for below. Save the SmartSlot coverPlug the UPS back into the AC power outlet Using straight-through UTP cables, connect the StaProcedure listed below Press and hold the Power On button until youInstallation Procedure As many as 32 stations, as shown below in . Note Use of a crossover cable to connect the Uplink ports2 central hubs Removing the Hub Troubleshooting Provides suggestions for troubleshooting your hubAction Cause Solution Troubleshooting Suggestions Specifications Port 10Base-T HubWarranty Information Technician will help solve the problem over ProcedureBe prepared to provide a description of the problem Authorization RMA numberConformity is Application of CouncilDirectives Standards to Which DeclaredW. a p c c . c o m