American Power Conversion AP9615 Secure the hub with the screws removed in Step, Port. See on

Installing the Hub continued

Installation	5 Secure the hub with the screws removed in Step 3.
procedure,	6 Using straight-through UTP cables, connect the Sta-
continued	tion ports (1X – 4X , in any order) to each worksta-
	tion’s 10Base-Tport or to the Uplink port of a hub to
	be connected in cascade.(See Figure 2 on page 4.)
	7 Connect the Uplink port, if applicable:
	• If connecting to another hub:
	– Use a straight-through cable to connect to a Sta-
	tion port. (See Figure 2 on page 4.)
	– Use a crossover cable to connect to the Uplink
	port. (See Figure 4 on page 10.)
	• If connecting the Uplink port to a workstation or
	other non-hub device:
	– Use a crossover cable. (See Figure 2 on page 4.)
	8 Turn on the UPS or device that now houses the hub.
	To turn on the UPS or device, follow the appropriate
	procedure listed below:
	Smart-UPS
	a Plug the UPS back into the AC power outlet.
	b Press and hold the Power On button until you
	hear a click and beep or until the power LED
	illuminates.
	c Power on the connected equipment.
	Matrix-UPS
	a Turn on the circuit breaker on the bottom left
	side on the back panel of the UPS.
	b Turn on the UPS via the front panel.
	c Power on the connected equipment.
	Continued on next page

8