Altinex MT105-101, MT105-100 manual General, Installation, Cleaning, FCC / CE Notice

Page 3

MULTI-TASKER™

PRECAUTIONS / SAFETY WARNINGS

1

Please read this manual carefully before using your MT105-100/101. Keep this manual handy for future reference. These safety instructions are to ensure the long life of your MT105-100/101and to prevent fire and shock hazard. Please read them carefully and heed all warnings.

1.1GENERAL

Qualified ALTINEX service personnel, or their authorized representatives, must perform all service.

1.2INSTALLATION

To prevent fire or shock, do not expose this unit to rain or moisture. Do not place the MT105-100/101in direct sunlight, near heaters or heat radiating appliances, or near any liquid. Exposure to direct sunlight, smoke, or steam can harm internal components.

Handle the MT105-100/101carefully. Dropping or jarring can damage the card.

Do not pull the cables that are attached to the MT105-100/101.

Insert the card carefully into the slots of the Multi-Tasker™ without bending any edges.

When removing a card, please make sure that the card to which it is attached is also pulled out simultaneously to prevent damage to the cable and connectors.

1.3CLEANING

Clean only the connector area with a dry cloth. Never use strong detergents or solvents, such as alcohol or thinner. Do not use a wet cloth or water to clean the card. Do not clean or touch any component or PCB.

1.4FCC / CE NOTICE

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their expense.

Any changes or modifications to the unit not expressly approved by ALTINEX, Inc. could void the user’s authority to operate the equipment.

400-0131-004

2

2

Image 3
Contents MT105-100/MT105-101 Troubleshooting Guide FCC / CE Notice InstallationCleaning GeneralMT105-100/MT105-101 Description of MT105-100/101 Diagram 1 Typical Setup Diagram 2 Internal View MT105-100 Diagram 3 Internal View MT105-101 VER Description of CommandsRS-232 Control 1 RS-232 InterfaceVER CnSSAVEDC04 STA1 Path Operation STA0Single Card Operation Group OperationOFF 10. …S Save11. …F Feedback ImO SW Switch12. …P Path ImOxFBD SID+n RSISIDn SIDnCi26. WR TestMATmXy HelpRMC RMG29. RD VER Summary of CommandsMenu Mode Menu Command DefinitionsSUB Menus Using Menu ModeMenu Types Main MenuESC Select Card/Group for ControlMenu Mode Examples Toll Free 1-800-ALTINEX Limited WARRANTY/RETURN Policy Contact InformationNo Display ALTINEX, INC