Device Manager Menus
UPS Control Options continued
The | ||
options are identical, with one exception: Symmetra Power Array and | ||
Symmetra Power | ||
Array | Note: For information about the Sleep Time setting which appears in | |
| ||
| the Web interface’s “Control” and “Configuration” pages, see | |
| the table in Shutdown parameters on page 45. | |
| With one exception, control actions are accessed through the Control | |
| menu in the Web interface and the Control Console. The Reset UPS To | |
| Defaults is a Configuration menu option in the Control Console. | |
| Note: Use the Control menu in the Control Console to access the | |
| diagnostic tests which are accessed through the Diagnostics | |
| option in the Web interface. For descriptions of the | |
| Simulate Power Failure, Start/Stop Runtime Calibration, and | |
| Test UPS Alarm options, see UPS Diagnostics Options on | |
| page 40. |
|
|
|
|
| Action | Definition |
|
|
|
| Turn UPS On | Turns the UPS on. |
|
|
|
| Turn UPS Off | Turns the UPS off after the Shutdown Delay described in the |
|
| table in Shutdown parameters on page 45. |
|
|
|
| Turn UPS Off | Causes the UPS to turn off after PowerChute plus has time to |
| Gracefully1 | shut down the server’s operating system safely. |
| Reboot UPS | Reboots the attached equipment by immediately causing the |
|
| UPS to turn off and then back on again. |
|
|
|
| Reboot UPS | Reboots the attached equipment by causing the UPS to turn |
| Gracefully1 | off and then back on again, after PowerChute plus has time to |
|
| safely shut down the server’s operating system. |
|
|
|
| Put UPS To Sleep | Turns the UPS immediately off for the period of time defined by |
|
| the Sleep Time setting described in the table in Shutdown |
|
| parameters on page 45. |
|
|
|
| Put UPS To Sleep | Turns the UPS off for the period of time defined by the Sleep |
| Gracefully1 | Time setting described in the table in Shutdown parameters |
|
| on page 45, after PowerChute plus has time to safely shut |
|
| down the server’s operating system. |
|
|
|
| Put UPS In/Take | Controls the use of bypass mode, which allows some |
| UPS Off Bypass | maintenance to be performed at a |
|
| Power Array model without turning off the UPS. |
|
|
|
| Reset UPS To | Resets all UPS parameters to their default settings. |
| Defaults |
|
|
|
|
| 1 For information about the | |
| much time PowerChute plus has available to shut down the server safely, see the | |
| table in Shutdown parameters on page 45. | |
|
|
|
Web/SNMP Management SmartSlot Card User’s Guide | 42 |