Chapter 3
Chapter 3:
Installation
Overview
This chapter will explain how to connect network devices to the Switch. The following diagram shows a typical network configuration.
Cable/ | Uplink |
|
DSL | via Fiber | Administrator’s |
Internet Modem Router | to Switch | Notebook |
Wireless Desktop Notebook
Access
Point
Typical Network Configuration
When you connect your network devices, make sure you don’t exceed the maximum cabling distance of 100 meters (328 feet).
Positioning the Switch
Before you choose a location for the Switch, observe the following guidelines:
•• Make sure that the Switch is accessible and that the cables can be connected easily.
•• Keep cabling away from sources of electrical noise, power lines, and fluorescent lighting fixtures.
•• Position the Switch away from water and moisture sources.
•• To ensure adequate air flow around the Switch, be sure to provide a minimum clearance of two inches (50mm).
•• Do not stack
Placement Options
There are three ways to physically install the Switch, either set the Switch on its four rubber feet for desktop placement, mount the switch in a
Installation
1U high rack for
Desktop Placement
1.Attach the rubber feet to the recessed areas on the bottom of the Switch.
2.Place the Switch on a desktop near an AC power source.
3.Keep enough ventilation space for the Switch and check the environmental restrictions mentioned in “Appendix D: Specifications” as you are placing the Switch.
4.Connect the Switch to network devices according to the Hardware Installation instructions below.
5 |