3Com 5017C-LS, 5017C with load sharing installation and operation guide Rack Mount Positions

Figure 2-2. Rack Mount Positions

Follow the steps below to mount the cable tray in your rack:

1.Attach the two rack mount flanges to the cable tray in the position you want as shown in Figure 2-2 using the eight (8) provided 8-32 x 1/4" flathead screws - four per side.

Note: You must tighten the screws completely to be flush with the rack mount flanges so the tray will fit in the rack.

2.Select a vacant position in the rack that is at least 10.5 inches (26.7 cm) from the top of the rack or the next higher unit in the rack.

3.Install the provided clip nuts onto the front of the rack where you want to attach the tray.

Installation and Troubleshooting 2 - 9