3Com 10002211 manual Default To select the default all, press Return

Page 23

What’s New at Revision 8.2.0?

17

Top-Level Menu

5Enter full to set the port to full-duplex mode or half to set the port to half-duplex mode.

Default The port’s current setting is indicated in brackets. To select this default, press Return. This action leaves the port duplex mode unchanged.

6Repeat steps 4 and 5 to configure all the selected ports in all the selected slots.

Changing the mode to full-duplex disables collision detection on these ports.

Intelligent Flow Management (IFM). Intelligent flow management (IFM) is a congestion control mechanism that is built into the CoreBuilder system. You should implement IFM on any Fast Ethernet port that has a high volume of traffic. By default, IFM is enabled on CoreBuilder module ports.

Congestion is caused when one or more devices send traffic to an already congested port. If the port is connected to another CoreBuilder system or to an end station, IFM minimizes packet loss and inhibits the sending device from generating more packets until the congestion ends.

Intelligent flow management is supported only on half-duplex ports. It is disabled on port that are configured for full-duplex mode. 3Com recommends that you disable IFM on network segments that are connected to repeaters.

To apply IFM to a half-duplex Fast Ethernet port:

1From the top level of the Administration Console, enter:

system

 

 

 

ethernet

summary

 

 

fddi

 

 

detail

s

 

 

duplexMode

tokenringfastEthernet

ifm

bridge

label

 

 

ip

 

 

portState

 

 

ipx

 

 

 

 

 

appletalk

 

 

 

snmp

 

 

 

analyzer

 

 

 

script

 

 

 

logout

 

 

 

ethernet fastEthernet ifm

A prompt similar to the following one appears:

Select slot(s) (10-12all):

This prompt indicates that the CoreBuilder 6000 system contains configurable Fast Ethernet ports in slots 10, 11, and 12.

2Enter the number(s) of the slot(s) that contain ports that you want to set to IFM mode:

10-12

Default To select the default all, press Return.

Image 23
Contents Corebuilder CoreBuilder Extended Switching Software Revision October 17United States Government Legends Contents IP Multicast Routing Vlans on the Corebuilder System 3COM Corporation Limited Warranty Dated May 30 CoreBuilder 6000 Extended Switching software from 3ComOverview Corebuilder 6000 Extended Switching Software Revision Updating Your System Software Remove diskette #3 using the following command Remove diskette #1 using the following commandRemove diskette #2 using the following command Following files are now in your /usr/lp6000R directory Remove diskette #4 using the following commandRemove diskette #5 using the following command LMM+ Loading SystemSoftware on \3com\lp6000R\image\lp6000R Documentation UserCorrections implemented at this release What’s New atRevision 8.2.3? To define an IP interface AxFDDI axFDDI group AxFDDIHistory axFDDI group Enter the number of the Vlan whose interface you are definingSystem prompts you for slot numbers To enable Spanning Tree transitions, enterTo disable Spanning Tree transitions, enter Displaying Bridge InformationSample display of bridge port information Corrections that are implemented at this release Revision 8.2.0?What’s New at Revision 8.2.0? System displays this message You receive the prompt to select each port’s duplex modeDefault To select the default all, press Return FTP Packet Filter Program Transfers via Snmp first telnet session is disconnected and the system displays Sample screen showing the display after the changes What’s New at Revision 8.2.0? This message is immediately overwritten with Power supply +5-volt input has failedPower supply +12-volt input has failed Power supply +5-volt input is restoredSystem Issues System nvdata reset System Issues New Imports section now looks like this Known ProblemsReceived ftpCommand Quit not completed errno Corebuilder 6000 Extended Switching Software Revision Snmp MIB Files Support for IP routing on the Fddi Switching Module FSM Configurable Source Route hop count limit Efsm LpBridgePortAddressLearnedEvent Corebuilder 6000 Extended Switching Software Revision Following parameters IP Multicast RoutingDisabling Igmp EnablingDisabling Dvmrp Interfaces Administering IPMulticast Example multicast interface configuration for the slot Multicast interfaceEnabling Multicast Interfaces Disabling Multicast InterfacesAddress of the remote multicast router AdministeringMulticast Tunnels ExampleEnter the Time To Live TTL threshold of the tunnel Associate a multicast tunnelEnter the IP address of the destination multicast router Enter the Dvmrp metric value of the tunnelDisplaying Routes Table A-1describes the fields in the route display Following display shows all available multicast routesMulticast Cache DisplayingFollowing display shows the multicast cache configuration Table A-2describes the fields in the CacheDisplay Remote Monitoring Rmon B Technology Implementation CoreBuilderSegment being monitored Table B-3 Supported Ethernet and Fddi Frame Size Buckets Rmon Groups Example of an Alarm Threshold Setting Alarm ThresholdsRmon Groups 3Com Transcend Rmon Agents Management Information Base MIB Figure B-3 Example of an Rmon MIB Counter Object Locations About VLANsCoreBuilder system, VLANs allow you to Create firewallsAppendix C Vlans on the Corebuilder System Protocol Suite SNA Layer 3 Addressing InformationHow CoreBuilder System Makes Flooding Decisions Modifying the Default VlanVlan Exception Flooding Overlapped IP VLANs Routing Between VLANs Displaying Vlan Information Administering VlansExample of a summary display for several VLANs Table D-1describes these statistics As an Efsm or a TMM Defining VlanInformation for a Traditional BridgeDefining Vlan Follow these steps to create a Vlan definition Information for An HSI Switch EngineEnter the subnetwork mask Enter the IP subnet address Enter the subnetwork mask Bridge vlan modify Bridge vlan remove Technical Support Access by Analog Modem Type go threecom Regional Sales Office Telephone Number 3Com Corporation Returning Products for Repair Page 3Com Corporation Limited Warranty Limitation of Liability