3Com 10002211 Administering, Multicast Tunnels, Example, Address of the remote multicast router

A-6 APPENDIX A: IP MULTICAST ROUTING

	Example:
	Select IP stack by slot (2,3,7,9-12all) [12]:
	Enter an IP interface index [1]: 2
	Enter Interface DVMRP metric [1]: 1
	Enter Interface TTL threshold [1]:
	Enter interface rate limit in KBits/sec [0]:
Administering	A multicast tunnel allows multicast packets to cross several unicast routers
Multicast Tunnels	to a destination router that supports multicast. A tunnel has two end points.
	The local end point is associated with an interface on the CoreBuilder router.
	When you define the tunnel, you specify the associated index on the local
	CoreBuilder router and then the characteristics of the tunnel. Tunnel
	characteristics are the same as those of an interface. You also specify the IP
	address of the remote multicast router.
	Not all multicast configurations require a tunnel. The only configurations
	that require a tunnel are those that require a connection between two
	multicast internetworks through one or more unicast routers.
Displaying	To display the IP multicast tunnels on the router:
Multicast Tunnels

1From the top level menu of the Administration Console, enter:

Top-Level Menu

ip multicast

tunnel display

system

2 Enter the slot of the switching module for which you want to display a

ethernet

interface

dvmrp

fddi

route

multicast interface.

tokenring

arp

igmp

➧display

bridge

➧multicast

interface

define

➧ip

udpHelper

➧tunnel

remove

ipx

routing

routeDisplay

Select IP

stack(s) by slot

(2,3,7,9-12all)

[9]:

appletalk

cacheDisplay

snmp

rip

analyzer

ping

script

statistics

logout

Example IP multicast tunnel configuration:

Index

Local Address

Remote Address Metric Threshold RateLimit State

1

158.101.112.204

137.39.229.98

2

255

500

pkts in:320069 pkts out:0

peers

137.39.229.98

(3.8) (0xe)