Bed_anl_.qxd 20.02.04 16:29 Seite 37
timer).
Repeat
>Use the arrow keys to mark the column Rep.
>Press OK.
A selection window will be opened, showing various suggestions for repeats.
1x Timer on once T Daily repeat
1 W Repeat once a week
>Use the up/down arrow keys to select the desired function.
>Press OK to accept the setting into memory.
Accepting data into memory
>When you have completed the programming, press the yellow function key Accept, to accept the data into memory.
If under the heading Programme you have selected a programme that is blocked in terms of Point 8.3, you will first have to enter the PIN code before the data will be accepted into memory.
>Press the TV/Radio key to revert to normal opera- tion.
Timer overview
The timer overview allows you to see at a glance all the timer events already programmed.
>First call up the menu Timer management as des- cribed above to go to the menu Timer overview.
>Use the up/down arrow keys to mark the line
Timer overview.
>Confirm by pressing OK.
If there are overlaps between timer events, these over- laps will be highlighted in red.
Changing timer programming
>To change an existing timer setting, use the up/down arrow keys to mark the timer event you wish to change.
>Press the yellow function key Change to go to the settings of the marked timer. Proceed to make the changes as set out in Point 7.15.1.2.
>When you have completed the programming, press the yellow function key Accept to accept the data into memory.
Deleting timer programming
>To delete an existing timer setting, use the up/down arrow keys to mark the setting.
37