PLANET IP PBX user’s manual
2.4On-board LAN Setup
The
1.Select System
2.Enter a new IP address and network mask.
3.Click “APPLY” to change the settings.
Note: By default PLANET IP PBX grants IP addresses to LAN devices via DHCP, and translates those addresses into its WAN IP address for access beyond the LAN subnet. As a result, modifying the system LAN IP subnet must also change DHCP pool and LAN routing (if any) accordingly. After configuration, go to Service
2.5LAN Routing
To enable static routing among LAN subnets, enter network information and the IP address of the corresponding gateway in the IP PBX’s LAN. It is important to assure that the given gateway IP address sits in the IP PBX’s LAN. Each subnet requires an entry even multiple subnets share the same gateway, unless masking does the same. Examples are adding IP Route IDs net1 and net2 with parameters 192.168.128.0/255.255.255.0, 192.168.129.0/255.255.255.0, shared gateway 192.168.1.254 respectively. Or, IP Route ID net1n2 with 192.168.128.0/255.255.254.0 and gateway 192.168.1.254 would do the same. Added routes enable routing immediately after clicking ADD. However, the IP PBX Service needs to be restarted to regard calls from designated LAN subnets as LAN traffic. Go to Service