Planet Technology IPX-1800N SIP Proxy Port, Auth. Name, Auth. Password, Registration Required

Page 40

PLANET IP PBX user’s manual

 

 

 

registration will be from a dynamic remote peer. Typical

 

 

 

application is to accept registration from an IP PBX at a

 

 

 

remote site with dynamic IP address. Once the remote IP

 

 

 

PBX registers, calls from local to remote can be made

 

 

 

reversely over the trunk.

 

SIP Proxy

 

Specify IP address (or fully qualified domain name) and

 

 

 

UDP port of the remote SIP proxy, which usually refer to the

 

SIP Proxy Port

 

 

 

SIP server on the ITSP side.

 

 

 

 

Auth. Name

 

Specify the name for authentication if different to the Trunk

 

 

Identifier.

 

 

 

 

Auth. Password

 

Give the password used for authentication on the remote

 

 

SIP proxy or registrar. Usually this is given by the ITSP.

 

 

 

 

 

 

 

 

 

 

Select if registration to a registrar is required to activate the

 

Registration Required

 

trunk. This is true for a remote IP PBX or an ITSP account,

 

 

 

however, may be not required in case of a SIP gateway.

 

SIP Registrar

Specify IP address (or fully qualified domain name) and

 

 

 

UDP port of the remote SIP registrar, which usually refer to

 

SIP Registrar Port

 

 

 

the SIP server on the ITSP side (same as proxy).

 

 

 

 

 

 

Select a routegroup to associate routes with this trunk.

 

 

 

Outbound calls match included route patterns could employ

 

Outbound Routegroup7

 

this trunk to hop onto a remote SIP domain.

 

 

) If there is not any appropriate routegroup to select

 

 

 

 

 

 

initially, one can come back later to revise it, once the

 

 

 

expected routegroup has been added.

 

 

 

 

 

 

 

When enabled DID, clicks an extension in the list to be an

 

 

 

unconditional destination for incoming calls to this trunk. Or

 

 

 

click bynumber and then enter configurations in DID Prefix

 

 

 

and DID Stripping to have the incoming calls directed to

 

 

 

the corresponding extension derived by number

 

DID of Extension

 

manipulation. The SIP trunk numbers is therefore regarded

 

 

 

as the direct line of the extension.

 

 

 

) If you set a DID extension in a trunk, then only that

 

 

 

extension can use this trunk to call out, and all

 

 

 

incoming calls to this trunk will connect to that

 

 

 

extension directly.

 

 

 

 

DID Prefix

A digit string to be prefixed to the incoming called number

 

 

 

 

7Please refer to 4.5 for details.

Image 40
Contents Isdn Internet Telephony PBX System IPX-1800N User’s Manual Copyright DisclaimerCE Declaration of conformity FCC NoticeTrademarks Weee WarningRevision Table of Contents Feature Configuration Overview Physical Interfaces Front Panel of IPX-1800N Rear Panel of IPX-1800NSystem Configuration Time Setup RTC SetupPBX System System Time ZoneOn-board WAN Setup Password boxesStatic IP PPPoEOn-board LAN Setup LAN RoutingDynamic DNS Setup QoS Setup Enable QoSDisable QoS VoIP Reserved bandwidthAdd a Service Edit a ServiceDelete a Service MaintenancePlanet IP PBX user’s manual Service Firmware UpgradeClient StateShutdown System selecting the fails, you can a power-offLogout NTP Service Enable NTP ServiceDisable NTP Service Snmp ServiceEnable Snmp Service Disable Snmp Service Click Disable, and click ApplyStun Service Enable Stun ServiceTftp Service Change DirectoryAdd a Folder Delete a FolderDisable Tftp Service Dhcp ServiceDownload a File Delete a FileDisable Dhcp Service Add Dhcp RangeEdit Dhcp Range Delete Dhcp RangeIP PBX Service ConfigurationBackup RestoreRestart RevertField User Configuration Add a UserEdit a User Delete a UserUser Group Configuration Add a User Group Edit a User GroupDelete a User Group Group IDAssociated PBX Features3 Device ConfigurationReachable User Groups Member ListSupplementary Configuration Enable Voice Activity DetectionDtmf mode Add a DeviceAdd an Extension Edit an ExtensionDelete an Extension Extension NumberUnavailable Timeout Advanced SettingsPickup Group Line TypeTimeout To Next Forward Play Unavailable ForwardPrompt Line In Use ForwardEnabled Edit an Analog PhonePots Port User5Timeout Before Forward Play Unavailable Forward PromptDot Route ConfigurationDelete a Route Route Group Configuration Route IDDestination Number Pattern Number of Stripped DigitsRoutegroup Configuration Settings Add a Route GroupEdit a Route Group Delete a Route GroupSIP Trunk Configuration Auth. Password SIP ProxySIP Proxy Port Auth. NameDid Stripping IVR List8Usergroup9 of Privilege Bandwidth SensitiveIsdn Pstn Trunk Configuration Signalling Switch TypeDelete an Isdn Pstn Trunk Trunk GroupUsergroup12 Privilege IVR List11Caller ID Add a Terminal Trunk Edit a Terminal TrunkDelete a Terminal Trunk Terminal IdentifierPots Setting IPX-2000, IPX-1803 and IPX-1804 only Terminal PasswordUsergroup13 of Privilege Parking Timeout Call ParkCall Park Pilot Number Available Parking LinesAdministrator PIN Add a Meet-me ConferenceEdit a Meet-me Conference Delete a Meet-me ConferenceMusic On Hold Add a MOH FileEdit a MOH File Delete a OH FileMOH file Configuration Settings Field Description Default MOHMedia File VoicemailMeet-me Prompts Voicemail Prompts Worktime Interactive Voice Response IVR Optional WorktimeAdd a new IVR Menu Edit an IVR Menu Delete an IVR MenuAll IVR Menus InfoNode Child RuleAction Data Active WorktimeOff-Hour Actions Actions listAdd an IVR Prompt Delete an IVR PromptMachine configurations on the IPX-1800N Voice communication via IP PBX system IPX-1800NMachine configurations on the VIP-153PT Machine configurations on the VIP-156 Test the scenarioVoice communication via IP PBX system IPX-1800N Auto-config Is the IP address of IPX-1800 Planet IP PBX user’s manual Machine configurations on the VIP-156 Isdn Pstn Trunk Procedure Planet IP PBX user’s manual Planet IP PBX user’s manual IPX-1800N communication is Going