SUPER MICRO Computer AS1020S-8 Overheat LED, Wake-On-Ring, Wake-On-LAN, Chassis Intrusion

Chapter 5: Advanced Serverboard Setup

Overheat LED

Connect an LED to the JOH1 header to provide warning of a chassis over- heating condition. See the table on the right for pin defi nitions.

Overheat LED

Pin Definitions (JOH1)

Pin# Defi nition

1+5V

2OH Active

Wake-On-Ring

The Wake-On-Ring header is desig- nated JWOR. This function allows your computer to receive and "wake- up" by an incoming call to the modem when in suspend state. See the table on the right for pin defi nitions. You must have a Wake-On-Ring card and cable to use this feature.

Wake-On-LAN

The Wake-On-LAN header is desig- nated JWOL1. See the table on the right for pin defi nitions. You must have a LAN card with a Wake-On-LAN connector and cable to use the Wake- On-LAN feature.

Chassis Intrusion

A Chassis Intrusion header is located at JL1. Attach the appropriate cable to inform you of a chassis intrusion.

JSLED

Wake-On-Ring

Pin Definitions

(JWOR)

Pin# Defi nition

1Ground (Black)

2 Wake-up

Wake-On-LAN

Pin Definitions

(JWOL1)

Pin# Defi nition

1+5V Standby

2Ground

3Wake-up

Chassis Intrusion

Pin Definitions (JL1)

Pin# Defi nition

1Intrusion Input

2 Ground

SCSI LED Activity Header Pin Definitions (JSLED)

The SCSI LED header is designated JSLED. This header is used to display all SATA activity. See the table on the right for pin defi nitions. Pins 6-9 are no connection. Pin 10 is absent.

Pin# Defi nition

1SATA0 Act.

2SATA1 Act.

3SATA2 Act.

4SATA3 Act.

5 Common

Pin# Defi nition

6NC

7NC

8NC

9NC

5-17