JLAN1/2 (Ethernet Ports)
Two Gigabit Ethernet ports (designated JLAN1 and JLAN2) are located beside the COM2 port. These Ethernet ports accept RJ45 type cables.
Compact Flash Power
Headers
ACompact Flash Card Power Connector is located at JWF1. For the Compact Flash Card to work properly, you will first need to connect the device's power cable to JWF1 and correctly set the Compact Flash Jumper (JP1).
Compact Flash
Power Header
Pin Definitions (JWF1)
Pin# Definition
1+5V
2Ground
3Signal
3rd Power Supply Fail Detect Header
Connect your power supply to J3P to provide you with warning of a power supply failure. The warning signal is passed through the PWR_LED pin to indicate a power failure. See the table on the right for pin definitions.
3rd Power Supply Fail
Detect Header
Pin Definitions (J3P)
Pin# Definition
1P/S 1 Fail Signal
2P/S 2 Fail Signal
3P/S 3 Fail Signal
4Alarm Reset
Note: This feature is only available when using redundant Supermicro power supplies.
SGPIO
SGPIO1 and SGPIO2 (Serial General Purpose Input/Output) provide a bus between the SATA controller and the SATA drive backplane to provide SATA enclosure management func- tions. Connect the appropriate cables from the backplane to the SGPIO1 and SGPIO2 header(s) to utilize SATA management functions on your system.
SGPIO Header
Pin Definitions (SGPIO1, SGPIO2)
Pin# | Definition | Pin # | Definition |
1 | NC |
| NC |
2 | |||
3 | Ground |
| Data |
4 | |||
5 | Load |
| Ground |
6 | |||
7 | NC |
| NC |
8 | |||
|
|
|
|
Note: NC indicates no connection.