SMC Networks SMCWBR 14-GM manual Set TCP/IP Protocol for Working with NAT Router

Page 41

The TCP/IP protocol shall be listed in the Network window. Click OK to complete the install

procedure and restart your PC to enable the TCP/IP protocol.

A.2 Set TCP/IP Protocol for Working with NAT Router

Click Start button and choose Settings, then click Control Panel.

Double click Network icon. Select the TCP/IP line that has been associated to your network card in the Configuration tab of the Network window.

40

Image 41

Contents Page SMCWBR14-GM Trademarks CopyrightFCC Interference Statement CE Declaration of ConformityTable of Contents Introduction FeaturesUser-Definable Application Sensing Tunnel Wireless functions High speed for wireless LAN connectionDMZ Host supported Statistics of WAN SupportedSystem Requirements Port Description Package ListHardware Ports and Buttons Ethernet router LED IndicatorsPort DevicesGetting Started Procedure for Hardware InstallationPinging 192.168.2.1 with 32 bytes of data Request timed out PingStart-up and Log Configuring Wireless Broadband RouterStatus Wizard Setup Wizard Select Time Zone Page Time Zone Password Settings System SettingsEnable / Disable Remote Management WAN Setup Page Page DNS LAN & Dhcp Server 802.1X Wireless SettingsWPA-PSK Radius Shared KeyWPA Mac00-50-18-00-0f-fe Mac00-50-18-00-0f-fd WDSWireless Distribution SystemAP2 AP3 AP1 Setting AP3 Setting AP2 SettingSpecial Application Virtual ServerPage Parental Control FirewallMAC Filter URL Website Blocking URL Blocking EnableEnable Advanced Firewall Settings Demilitarized Zone DMZ Dynamic DNS Services UPnP Firmware Upgrade Configuration ToolsReset To Factory Defaults Backup SettingsAppendix a TCP/IP Configuration for Windows 95/98Install TCP/IP Protocol into Your PC Set TCP/IP Protocol for Working with NAT Router Page Don’t input any value in the Gateway tab Page Page Equipment Details Testing Environment Use Windows 2000 Radius ServerDUT and Windows 2000 Radius Server Setup DUT ConfigurationPage Enable Ieee 802.1X access control Eaptls Certificate information on PC1 Authentication success Page WPA-PSK Open Adapters Add and edit some settings Page Page Page WPA Page Then Choose certificate like above Page Page Go Network and Select 1 and ok Page Page Client Restore directly when the router power on Restore with Reset buttonTesla Irvine, CA Phone 949