SMC Networks SMCWBR 14-GM manual LED Indicators, Ethernet router, Port, Devices

Page 9

WAN

the port where you will connect your cable (or DSL) modem or

 

Ethernet router.

Port 1-4

the ports where you will connect networked computers and other

 

devices.

LED Indicators

Front Panel

Figure 1-2 Front Panel

LED:

LED

Function

Color

Status

Description

 

 

 

 

 

Power

Power

Green

On

Power is being applied to this product.

 

indication

 

 

 

 

 

 

 

 

Status

System

Green

Blinking

Status is flashed once per second to indicate system is alive.

 

status

 

 

 

 

 

 

 

 

WAN

WAN port

Green

On

The WAN port is linked.

 

activity

 

 

 

 

 

 

 

 

 

 

 

Blinking

The WAN port is sending or receiving data.

WLAN

Wireless

Green

 

 

Blinking

Sending or receiving data via wireless

 

activity

 

 

 

 

 

 

 

 

8

Image 9
Contents Page SMCWBR14-GM Trademarks CopyrightFCC Interference Statement CE Declaration of ConformityTable of Contents Introduction FeaturesUser-Definable Application Sensing Tunnel Wireless functions High speed for wireless LAN connectionDMZ Host supported Statistics of WAN SupportedSystem Requirements Package List Hardware Ports and ButtonsPort Description Ethernet router LED IndicatorsPort DevicesGetting Started Procedure for Hardware InstallationPinging 192.168.2.1 with 32 bytes of data Request timed out PingStart-up and Log Configuring Wireless Broadband RouterStatus Wizard Setup Wizard Select Time Zone Page Time Zone Password Settings System SettingsEnable / Disable Remote Management WAN Setup Page Page DNS LAN & Dhcp Server 802.1X Wireless SettingsWPA-PSK Radius Shared KeyWPA WDSWireless Distribution System AP2 AP3Mac00-50-18-00-0f-fe Mac00-50-18-00-0f-fd AP1 Setting AP3 Setting AP2 SettingSpecial Application Virtual ServerPage Parental Control FirewallMAC Filter URL Blocking Enable EnableURL Website Blocking Advanced Firewall Settings Demilitarized Zone DMZ Dynamic DNS Services UPnP Firmware Upgrade Configuration ToolsReset To Factory Defaults Backup SettingsTCP/IP Configuration for Windows 95/98 Install TCP/IP Protocol into Your PCAppendix a Set TCP/IP Protocol for Working with NAT Router Page Don’t input any value in the Gateway tab Page Page Equipment Details Testing Environment Use Windows 2000 Radius ServerDUT and Windows 2000 Radius Server Setup DUT ConfigurationPage Enable Ieee 802.1X access control Eaptls Certificate information on PC1 Authentication success Page WPA-PSK Open Adapters Add and edit some settings Page Page Page WPA Page Then Choose certificate like above Page Page Go Network and Select 1 and ok Page Page Client Restore directly when the router power on Restore with Reset buttonTesla Irvine, CA Phone 949