Seagate ST19171N, ST19171DC, ST19171WD, ST19171WC manual Drive models, General information

Page 22

20	Barracuda 9 Installation Guide, Rev. B

Initial setup information

The general information beginning on this page applies to all of the Barracuda 9 drive models. After reading the general informa- tion topics, refer to the appropriate drive-specific section listed below for additional information about configuring and installing your particular model.

Drive models		Page
ST19171N		32
ST19171W	ST19171WD	36
ST19171WC	ST19171DC	41

General information

The following general information topics are discussed:

•SCSI ID jumpers

•Drive termination

•Terminator power

•Interface drivers and data path width notes

•Other applicable jumper options

•Providing adequate cooling

•Mounting the drive and connecting cables*

•Formatting the drive

*This mounting procedure does not apply to WC or DC model drives. To mount a WC or DC drive, plug the drive into the sys- tem’s single connector attachment (SCA) position on the sys- tem’s back panel.

Image 22

Contents ST19171N/W/WD/WC/DC Contents Preface Electrostatic discharge protectionImportant safety information and precautions Page Wichtige Sicherheitshinweise Barracuda 9 Installation Guide, Rev. B Barracuda 9 Installation Guide, Rev. B Page Regulatory agency compliance Electromagnetic susceptibilityElectromagnetic compliance for the European Union Seagate technical support services Online servicesSeagate CompuServe forum FAX services SeaFAXDirect-support services Seagate technical supportCustomer service centers Manufacturer’s representativesGeneral description Characteristics ST19171 OD DC Barracuda 9 Installation Guide, Rev. B Page Drive models General informationScsi ID jumpers Drive terminationScsi bus termination Circuits and data path widths Terminator powerProviding adequate cooling Barracuda 9 Installation Guide, Rev. B Kühlung des Systems Suggested air flow Abbildung 3. Empfohlener Luftstromverlauf Mounting the drive and connecting cables Installation des Laufwerkes und Anschluß der KabelBarracuda 9 Installation Guide, Rev. B DC power connector Abbildung 4. Gleichstromanschluß Hinweis Formatting the drive Quick reference desktop system notesSetting the Scsi ID jumpers DrivesTerminating the drive Terminating the driveSetting terminator power jumpers Other applicable jumper options Several other jumper options are available as illustratedWD drives Using the J1 auxiliary jumper block Terminating the drive ST19171W shown ST19171W Other option jumpers are available as illustrated below WC/DC drives Applicable jumper options Option jumpers are available as illustrated belowPage Page