3.4Drive mounting
You can mount the drive using four screws in the
•Allow a minimum clearance of 0.030 inches (0.76 mm) around the entire perimeter of the drive for cooling.
•Use only M3 UNC mounting screws.
•Do not overtighten the mounting screws. Maximum torque: 4.0
•Four (4) threads (0.080 inches, 2.032 mm) minimum screw engagement recommended.
•Avoid excessive drive distortion when mounting.
Measurements shown in Figure 4 are in inches.
3.95
Breather Hole |
|
|
|
Do not cover | + |
|
|
or seal. |
| Recommended | |
|
|
| case temperature |
|
|
| measurement |
|
|
| location |
Figure 4. Mounting dimensions
Momentus 7200 FDE.1 SATA Product Manual, Rev. A | 23 |