3.0Configuring and mounting the drive
This section contains the specifications and instructions for configuring and mounting the drive.
Momentus® 7200 FDE.1 SATA drives may be connected to any computer system that supports a standard SATA interface.
You can elect to use Momentus 7200 FDE.1 SATA drives in one of two different security modes:
1.The ATA Security mode
To operate in ATA Security mode, you only need a host system and operating system that supports the existing ATA Security Command Set. The drive is shipped to operating in this mode, ready to use.
2.The DriveTrust Security mode
To enable a robust
Refer to Table 1 on page 2 to determine which mode is best for your particular solution.
Note. As with any disc drive, Seagate highly encourages consumers to consistently back up their data as well as the security
3.1Handling and static-discharge precautions
After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and
Caution:
•Keep the drive in the electrostatic discharge (ESD) bag until you are ready for installation to limit the drive’s exposure to ESD.
•Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.
•Handle the drive only by its edges or frame.
•The drive is
•Always rest the drive on a padded, antistatic surface until you mount it in the computer.
•Do not touch the connector pins or the printed circuit board.
•Do not remove the
Momentus 7200 FDE.1 SATA Product Manual, Rev. A | 21 |