Seagate 275XE, 545XE manual Transferring and using the installation software, Type format a/s

Page 13

Medalist XE Family Installation Guide, Rev. A

11

 

 

 

drive: designates the drive you are formatting. Type c: if you are formatting the boot drive or if your system contains only one drive. Type d: to format a second drive.

/v tells the computer you want to label the drive after it is formatted. Labeling the drive can prevent someone from ac- cidentally deleting the partition and losing your data.

/s tells the computer to make the drive bootable and copy the necessary system files to the drive.

2.When the computer prompts you for a volume label, type any valid name you want to designate the partition.

Transferring and using the installation software

Before you partition and format the drive, you must transfer the hard disc installation files on the drive to a bootable diskette in Drive A. The diskette must have 300 Kbytes available. To create a bootable diskette:

1.Put your DOS diskette into Drive A.

2.Type format a:/s.

The drive will read the DOS diskette and ask you to insert the diskette you want to format into Drive A.

3.Insert the blank diskette. Press ENTER. When the format is complete, you can transfer the installation software files to the diskette.

Transferring the installation software

1.Boot the computer with the diskette to which you want to transfer the installation software files.

2.Enter the System Setup routine. (Refer to your computer user’s guide. System Setup may be called Setup, BIOS Setup or CMOS Setup.) If your computer uses an automatic setup system, go to step 5.

3.Find the hard disc configuration in the System Setup screen.

Image 13
Contents 275xe, 545xe ATA Interface Drives Contents Read before you begin Quick software transfer ST3660A free installation softwareJumpers and connectors Configuring the drive Installing the driveConnect the remote LED optional Attaching cablesMounting the drive Installing drives in computers that use cable-selectMbyte system-capacity limit Configuring the computerModel Mbytes Cyl Heads Sectors Setup Standard installationTranslation geometry Low-level formatting Partitioning and formatting the driveHigh-level formatting PartitioningTransferring the installation software Transferring and using the installation softwareType format a/s Type seamove Using the installation softwarePage Medalist XE Family Installation Guide, Rev. a Hold the Ctrl key down to boot from a floppy Booting with a diskette after EZ-Drive is installedInstalling multiple partitions Hold the Ctrl key down to boot from a floppy Page Basic troubleshooting System does not recognize the drive Advanced troubleshootingScreen remains blank when you power up the system System error message, Drive not Ready, appears System error message, HDD controller failure appears Disabling EZ-Drive Disabling Maximum Overdrive SeaBOARD Technical support servicesLocation Modem number Location Telephone number SeaFAXSeagate Technical Support FAX /438-8137 SeaFONE /438-8222Seagate CompuServe forum Drive in an approved package Storing and shipping your drive