Medalist XE Family Installation Guide, Rev. A | 5 |
Attaching cables
Refer to Figure 1 on page 3 for the locations of the connectors.
1.Connect the remote LED (optional).
2.Attach the power cable. Attach one of the cables from the power supply to the power connector on the drive.
Caution. The cable and connector are designed to mate. Do not force a connection. Improper alignment may damage your drive.
3.Attach the interface cable. The edge-stripe on the interface cable for the drive is used to denote pin 1. The cable length must be no longer than 18 inches.
Caution. Cable misalignment can result in damage to the com- puter and the drive. Ribbon cables are delicate—be careful not to crimp or strain them.
Installing one drive with a standard ATA 40-pin interface cable:
Attach one end of the cable to the drive’s 40-pin ATA interface connector. Align the cable’s edge-stripe with pin 1 of the drive shown in Figure 1. Attach the other end of the cable to the host adapter card or to the hard drive connector located on the motherboard. Align the cable’s edge-stripe with pin 1 (see your system user’s guide or host adapter user’s guide).
Installing two drives with an ATA interface cable:
You need an interface cable designed for two drives. Attach a cable connector to each drive’s 40-pin ATA interface connec- tor. Align the cable’s edge-stripe with pin 1 of the drive shown in Figure 1. Attach the other end of the cable to the host adapter card or to the hard drive connector located on the motherboard. Align the cable’s edge-stripe with pin 1 (see your system user’s guide or host adapter user’s guide). You can attach the drives in any order on the cable.
