Seagate 545XE, 275XE manual Hold the Ctrl key down to boot from a floppy

Page 18

16

Medalist XE Family Installation Guide, Rev. A

The computer will reboot when the partitioning process is com- plete. However, you must make sure the EZ-Drive installed drive is present to continue with the format. (The EZ-Drive banner appears when the drive is recognized.)

1.Open the diskette-drive door when you reboot. Press the CTRL key when the following message appears:

Hold the CTRL key down to boot from a floppy

The message is very quick and you may need to boot several times before you succeed. (Some computers allow you to press the CTRL key early.) If you get an “Invalid OS” error message, the computer has not found the EZ-Drive installed drive and you must start the boot process again.

2.Insert a DOS diskette with the format program.

3.Type format drive: for each partition you have created.

Note. DOS automatically assigns a letter to each partition. Use the appropriate letter in the format statement.

If you are formatting Drive C, you must copy the system files for the computer to boot from the drive. To copy the system files during the format, type format c: /s.

4.Reboot the computer when you are done formatting. Windows32-bit disk access.

If 32-bit disk access is enabled in your Microsoft® Windows, a device conflict message appears when you load Windows after you install your drive with EZ-Drive. To resolve the conflict:

1.Press ENTER to open Windows.

2.Open the Main menu.

3.Open the Control Panel.

4.Select Virtual Memory.

5.Select Change.

6.Disable 32-Bit Disk Access at the bottom of the screen.

7.Select OK. Follow the screen instructions to reboot.

Image 18
Contents 275xe, 545xe ATA Interface Drives Contents Read before you begin ST3660A free installation software Quick software transferJumpers and connectors Installing the drive Configuring the driveAttaching cables Connect the remote LED optionalInstalling drives in computers that use cable-select Mounting the driveConfiguring the computer Mbyte system-capacity limitStandard installation Model Mbytes Cyl Heads Sectors SetupTranslation geometry Partitioning and formatting the drive Low-level formattingPartitioning High-level formattingTransferring and using the installation software Transferring the installation softwareType format a/s Using the installation software Type seamovePage Medalist XE Family Installation Guide, Rev. a Booting with a diskette after EZ-Drive is installed Hold the Ctrl key down to boot from a floppyInstalling multiple partitions Hold the Ctrl key down to boot from a floppy Page Basic troubleshooting Advanced troubleshooting System does not recognize the driveScreen remains blank when you power up the system System error message, Drive not Ready, appears System error message, HDD controller failure appears Disabling EZ-Drive Disabling Maximum Overdrive Technical support services SeaBOARDLocation Modem number Seagate Technical Support FAX /438-8137 SeaFAXLocation Telephone number SeaFONE /438-8222Seagate CompuServe forum Storing and shipping your drive Drive in an approved package