Seagate 545XE, 275XE manual Basic troubleshooting

Page 20

18

Medalist XE Family Installation Guide, Rev. A

Basic troubleshooting

Warning. Always turn off the computer before changing jumpers or unplugging cables and cards.

Caution. Your drive and computer contain static-sensitive de- vices. Wear a ground strap or take other antistatic precaution while handling your drive.

If you have installed your drive and it does not function properly, perform the following basic checks.

Verify compatibility. Verify that the host adapter and the drive are appropriately matched to each other and to your computer. Refer to relevant documentation for details.

Check all cards. Verify that all cards are seated in their slots on the motherboard and are secured with mounting screws.

Check all cables. Make sure all ribbon and power cables are securely connected. Ribbon cables are easily damaged, es- pecially at the connector. Try a new cable or a known good cable. Make sure no socket pins were bent when the cable was inserted. For each cable, verify that cable-connector pin 1 is aligned with equipment-connector pin 1. The edge-stripe on the ribbon cable is used to denote pin 1.

Caution. Do not reverse-plug connectors. This can damage the computer and the drive.

Verify equipment configuration. Review the instructions in this guide and the host adapter installation guide and make sure that all appropriate jumpers are installed, or removed, to suit your application.

Check the power-supply specifications. If new devices are installed, your computer’s power supply may not support the new total power requirement. Consult your dealer.

Verify the drive type setting in System Setup. The drive type stored in CMOS memory by your System Setup program must not exceed the physical specifications of your drive. Also,

Image 20
Contents 275xe, 545xe ATA Interface Drives Contents Read before you begin ST3660A free installation software Quick software transferJumpers and connectors Installing the drive Configuring the driveAttaching cables Connect the remote LED optionalInstalling drives in computers that use cable-select Mounting the driveConfiguring the computer Mbyte system-capacity limitTranslation geometry Standard installationModel Mbytes Cyl Heads Sectors Setup Partitioning and formatting the drive Low-level formattingPartitioning High-level formattingType format a/s Transferring and using the installation softwareTransferring the installation software Using the installation software Type seamovePage Medalist XE Family Installation Guide, Rev. a Installing multiple partitions Booting with a diskette after EZ-Drive is installedHold the Ctrl key down to boot from a floppy Hold the Ctrl key down to boot from a floppy Page Basic troubleshooting Advanced troubleshooting System does not recognize the driveScreen remains blank when you power up the system System error message, Drive not Ready, appears System error message, HDD controller failure appears Disabling EZ-Drive Disabling Maximum Overdrive Location Modem number Technical support servicesSeaBOARD SeaFAX Location Telephone numberSeagate Technical Support FAX /438-8137 SeaFONE /438-8222Seagate CompuServe forum Storing and shipping your drive Drive in an approved package