Seagate 275XE, 545XE manual Partitioning and formatting the drive, Low-level formatting

Page 11

Medalist XE Family Installation Guide, Rev. A

9

1,057 – 1,024 = 33, or 17.3 Mbytes. To avoid this problem, configure your System Setup manually.

If none of the standard drive types offered in System Setup match the translation geometry of your Seagate drive, select the user-defined or custom drive type, if available, and enter your drive’s translation geometry.

If your System Setup routine does not offer a user-defined drive type, select a standard drive type with a capacity that approximates, but does not exceed, the capacity listed in the table on page 8 under CMOS (Setup) Mbytes.

If System Setup does not list the drive types it supports, you can get assistance choosing an appropriate drive type by downloading the FindType utility from the Seagate Sea- BOARDbulletin board (see page 25).

The drive does not use write precomp and landing zone. If these parameters are listed, make their value zero.

If you upgrade your system at a later date to achieve the drive’s full capacity, you must repartition and reformat the disc. Be sure to save your data first.

5.When you have completed setting the translation geometry for your drive, save the values and exit System Setup. Reboot your computer. Refer to your user’s guide for assistance on saving your changes.

Partitioning and formatting the drive

Before you can use your Seagate drive, you must partition and format it. In this guide we discuss partitioning and formatting your drive with DOS; have your DOS user’s guide available for refer- ence. If you are using another operating system, consult your operating system user’s guide for formatting instructions.

Low-level formatting

Your drive is low-level formatted at the factory to 512 bytes per sector. Low-level formatting is not required.

Image 11
Contents 275xe, 545xe ATA Interface Drives Contents Read before you begin Quick software transfer ST3660A free installation softwareJumpers and connectors Configuring the drive Installing the driveConnect the remote LED optional Attaching cablesMounting the drive Installing drives in computers that use cable-selectMbyte system-capacity limit Configuring the computerTranslation geometry Standard installationModel Mbytes Cyl Heads Sectors Setup Low-level formatting Partitioning and formatting the driveHigh-level formatting PartitioningType format a/s Transferring and using the installation softwareTransferring the installation software Type seamove Using the installation softwarePage Medalist XE Family Installation Guide, Rev. a Installing multiple partitions Booting with a diskette after EZ-Drive is installedHold the Ctrl key down to boot from a floppy Hold the Ctrl key down to boot from a floppy Page Basic troubleshooting System does not recognize the drive Advanced troubleshootingScreen remains blank when you power up the system System error message, Drive not Ready, appears System error message, HDD controller failure appears Disabling EZ-Drive Disabling Maximum Overdrive Location Modem number Technical support servicesSeaBOARD SeaFONE /438-8222 SeaFAXLocation Telephone number Seagate Technical Support FAX /438-8137Seagate CompuServe forum Drive in an approved package Storing and shipping your drive