Seagate 275XE, 545XE manual

Page 19

Medalist XE Family Installation Guide, Rev. A	17

You can re-establish the 32-bit disk access capability using the SETUP program on the EZ-Drive diskette as follows:

1.Load Windows.

2.Open the Program Manager menu and select File.

3.Select Run.

4.Load the EZ-Drive diskette.

5.In the command line box, type drive:Setup.

6.Select Install Driver. This loads the MH32BIT.386 replace- ment driver designed to work with EZ-Drive.

7.Select Restart Windows.

Image 19

Contents 275xe, 545xe ATA Interface Drives Contents Read before you begin Quick software transfer ST3660A free installation softwareJumpers and connectors Configuring the drive Installing the driveConnect the remote LED optional Attaching cablesMounting the drive Installing drives in computers that use cable-selectMbyte system-capacity limit Configuring the computerModel Mbytes Cyl Heads Sectors Setup Standard installationTranslation geometry Low-level formatting Partitioning and formatting the driveHigh-level formatting PartitioningTransferring the installation software Transferring and using the installation softwareType format a/s Type seamove Using the installation softwarePage Medalist XE Family Installation Guide, Rev. a Hold the Ctrl key down to boot from a floppy Booting with a diskette after EZ-Drive is installedInstalling multiple partitions Hold the Ctrl key down to boot from a floppy Page Basic troubleshooting System does not recognize the drive Advanced troubleshootingScreen remains blank when you power up the system System error message, Drive not Ready, appears System error message, HDD controller failure appears Disabling EZ-Drive Disabling Maximum Overdrive SeaBOARD Technical support servicesLocation Modem number SeaFONE /438-8222 SeaFAXLocation Telephone number Seagate Technical Support FAX /438-8137Seagate CompuServe forum Drive in an approved package Storing and shipping your drive