Seagate ST34573N/W/WD/LW/WC/LC manual DC power requirements Amps, single-ended ST39173N/W/WC, Dcx

Page 19

Barracuda 9LP Installation Guide, Rev. E

17

Table 2a. DC power requirements (Amps), single-ended

 

 

 

ST39173N/W/WC

ST34573N/W/WC

Voltage

+5V

+12V

+5V

+12V

Regulation [5]

±5%

±5%[2]

±5%

±5%[2]

Max. operating current

 

 

 

 

DC [1]

1.15

0.95

1.15

0.95

Avg. idle current

 

 

 

 

 

 

[1]

0.75

0.5

0.75

0.5

DCX

Max. starting current

 

 

 

 

(peak DC) [3]

1.2

1.7

1.2

1.7

(peak AC) [3]

2.9

2.9

Delayed motor

 

 

 

 

start (max) [1][4]

0.65

0.06

0.65

0.06

Peak operating current

 

 

 

 

Typical DCX [1][6]

1.05

0.9

1.05

0.9

Maximum DC [1]

1.15

0.95

1.15

0.95

Maximum (peak)

1.7

2.4

1.7

2.4

Notes for this table follows Table 2c.

Image 19
Contents ST39173N/W/WD/LW/WC/LC ST34573N/W/WD/LW/WC/LC Contents Electrostatic discharge protection PrefaceImportant safety information and precautions Page Wichtige Sicherheitshinweise Page Barracuda 9LP Installation Guide, Rev. E Electromagnetic susceptibility Regulatory agency complianceElectromagnetic compliance Australian C-Tick Electromagnetic compliance for the European UnionSeagate Technology support services Presales Support Customer Service CSO European Support Services Africa/Middle East Support Services 14Barracuda 9LP Installation Guide, Rev. E General description RPM Drive characteristicsDCX DC power requirements Amps, single-ended ST39173N/W/WCDCX ST39173LW/LC ST34573LW/LC DC power requirements Amps, multimodeDimensions of the drive General information Drive modelsScsi ID jumpers Drive termination Circuits and data path widths Terminator powerCable characteristics for single-ended I/O circuits Cable characteristics for differential I/O circuits Fifty pin I/O connection to drive Multiple drive connection to host adapter Multiple-drive connection to host adapter Barracuda 9LP Installation Guide, Rev. E Providing adequate cooling Kühlung des Systems Suggested air flow Abbildung 4. Empfohlener Luftstromverlauf Installation des Laufwerkes und Anschluß der Kabel Mounting the drive and connecting cablesPage DC power connector Abbildung 5. Gleichstromanschluß Hinweis Barracuda 9LP Installation Guide, Rev. E Mounting configuration dimensions Formatting the drive Quick reference desktop system notes Drives Setting the Scsi ID jumpersTerminating the drive Terminating the driveSetting terminator power jumpers Additional jumper options Other applicable jumper optionsWD/LW drives Setting the Scsi ID on model W/WD drivesHost Alternate Terminating the drive W model shown WD drivesWD model drives Additional jumper options for W, WD, and LW drives Additional jumper option for LW drives LW drivesWC/LC drives Applicable jumper options WC drivesJumper options for LC drives LC drivesAdditional jumper options for LC drives Page