Seagate ST34573N/W/WD/LW/WC/LC, ST39173N/W/WD/LW/WC/LC manual Quick reference desktop system notes

Page 43

Barracuda 9LP Installation Guide, Rev. E

41

Quick reference desktop system notes

Note. Refer to your system or utility manual for detailed instruc- tions)

DOS. Set the drive type in CMOS to “ Zero,” “None,” or “No hard drive installed.” Use FDISK.EXE and FORMAT.EXE. Sys- tems that have operating system Windows 95 release 950B or later do not need to partition the drive.

Macintosh. Use a third-party drive utility (Apple’s HD Setup utility only works with drives having special Apple firmware).

Image 43
Contents ST39173N/W/WD/LW/WC/LC ST34573N/W/WD/LW/WC/LC Contents Electrostatic discharge protection PrefaceImportant safety information and precautions Page Wichtige Sicherheitshinweise Page Barracuda 9LP Installation Guide, Rev. E Electromagnetic susceptibility Regulatory agency complianceElectromagnetic compliance Australian C-Tick Electromagnetic compliance for the European UnionSeagate Technology support services Presales Support Customer Service CSO European Support Services Africa/Middle East Support Services 14Barracuda 9LP Installation Guide, Rev. E General description RPM Drive characteristicsDCX DC power requirements Amps, single-ended ST39173N/W/WCDCX ST39173LW/LC ST34573LW/LC DC power requirements Amps, multimodeDimensions of the drive General information Drive modelsScsi ID jumpers Drive termination Circuits and data path widths Terminator powerCable characteristics for single-ended I/O circuits Cable characteristics for differential I/O circuits Fifty pin I/O connection to drive Multiple drive connection to host adapter Multiple-drive connection to host adapter Barracuda 9LP Installation Guide, Rev. E Providing adequate cooling Kühlung des Systems Suggested air flow Abbildung 4. Empfohlener Luftstromverlauf Installation des Laufwerkes und Anschluß der Kabel Mounting the drive and connecting cablesPage DC power connector Abbildung 5. Gleichstromanschluß Hinweis Barracuda 9LP Installation Guide, Rev. E Mounting configuration dimensions Formatting the drive Quick reference desktop system notes Drives Setting the Scsi ID jumpersTerminating the drive Terminating the driveSetting terminator power jumpers Additional jumper options Other applicable jumper optionsWD/LW drives Setting the Scsi ID on model W/WD drivesHost Alternate Terminating the drive W model shown WD drivesWD model drives Additional jumper options for W, WD, and LW drives Additional jumper option for LW drives LW drivesWC/LC drives Applicable jumper options WC drivesJumper options for LC drives LC drivesAdditional jumper options for LC drives Page