Seagate ST34573N/W/WD/LW/WC/LC, ST39173N/W/WD/LW/WC/LC manual Drive models, General information

Page 23

Barracuda 9LP Installation Guide, Rev. E

21

Initial setup information

The general information beginning on this page applies to all of the Barracuda 9LP drive models. After reading the general infor- mation topics, refer to the appropriate drive-specific section listed below for additional information about configuring and installing your particular model.

Drive models		Page
ST39173N	ST34573N	42
ST39173W/WD/LW	ST34573W/WD/LW	46
ST39173WC/LC	ST34573WC/LC	52

General information

The following general information topics are discussed:

•SCSI ID jumpers

•Drive termination

•Terminator power

•Interface drivers and data path width notes

•Other applicable jumper options

•Providing adequate cooling

•Mounting the drive and connecting cables1

•Formatting the drive

1This mounting procedure does not apply to “WC” or “LC” model drives. To mount a “WC” or “LC” drive, plug the drive into the system’s single connector attachment (SCA) position on the system’s back panel.

Image 23

Contents ST39173N/W/WD/LW/WC/LC ST34573N/W/WD/LW/WC/LC Contents Electrostatic discharge protection PrefaceImportant safety information and precautions Page Wichtige Sicherheitshinweise Page Barracuda 9LP Installation Guide, Rev. E Electromagnetic compliance Regulatory agency complianceElectromagnetic susceptibility Australian C-Tick Electromagnetic compliance for the European UnionSeagate Technology support services Presales Support Customer Service CSO European Support Services Africa/Middle East Support Services 14Barracuda 9LP Installation Guide, Rev. E General description RPM Drive characteristicsDCX DC power requirements Amps, single-ended ST39173N/W/WC DCX ST39173LW/LC ST34573LW/LC DC power requirements Amps, multimodeDimensions of the drive General information Drive modelsScsi ID jumpers Drive termination Circuits and data path widths Terminator powerCable characteristics for single-ended I/O circuits Cable characteristics for differential I/O circuits Fifty pin I/O connection to drive Multiple drive connection to host adapter Multiple-drive connection to host adapter Barracuda 9LP Installation Guide, Rev. E Providing adequate cooling Kühlung des Systems Suggested air flow Abbildung 4. Empfohlener Luftstromverlauf Installation des Laufwerkes und Anschluß der Kabel Mounting the drive and connecting cablesPage DC power connector Abbildung 5. Gleichstromanschluß Hinweis Barracuda 9LP Installation Guide, Rev. E Mounting configuration dimensions Formatting the drive Quick reference desktop system notes Drives Setting the Scsi ID jumpersTerminating the drive Terminating the driveSetting terminator power jumpers Additional jumper options Other applicable jumper optionsWD/LW drives Setting the Scsi ID on model W/WD drivesHost Alternate Terminating the drive W model shown WD drivesWD model drives Additional jumper options for W, WD, and LW drives Additional jumper option for LW drives LW drivesWC/LC drives Applicable jumper options WC drivesJumper options for LC drives LC drivesAdditional jumper options for LC drives Page