Seagate ST34573N/W/WD/LW/WC/LC, ST39173N/W/WD/LW/WC/LC manual Mounting configuration dimensions

Barracuda 9LP Installation Guide, Rev. E 39

[3]

C

[1]

E

G

D

F

A

Notes:

	[1]	Mounting holes three on each side, 6-32 UNC. Max
		screw length into side of drive 0.15 in. (3.81 mm).
		Screw tightening torque 6.0 in-lb (.675 NM) max with
		minimum thread engagement of 0.12 in. (3.05 mm).
	[2]	Mounting holes four on bottom, 6-32 UNC. Max screw
		length into bottom of drive 0.15 in. (3.81 mm). Screw
		tightening torque 6.0 in-lb (.675 NM) max with minimum
		thread engagement of 0.12 in. (3.05 mm).
B	[3]	Power and interface connectors can extend past the
		“A” dimension by 0.040 in. (1.02 mm).
	[4]	Centerline of pad for Pin 1 of power connector.
J	[5]	Centerline of pad for Pin 1 of J6.
	[4] L	Centerline of pad for Pin 1 of J2. Dimensions indicated
	[6]
		are for reference only.
K	[7]	Dimensions to Pin 1 of each connector are nominal
		values.

[2]	[8]	To pin ends on J6. Pin ends on J6 are nominally flush
		with end of drive.
M [6]			Dimension Table
J2			Inches		Millimeters
[6] N		A	5.75	± .025	146.05	± .64
H
		B	4.00	± .015	101.60	± .38
		C	1.002	+ .027	25.45	+ .69
				– .21		– .53
		D	2.362	± .010	60.00	± .25
		E	1.120	± .020	28.45	± .51
		F	4.000	± .010	101.60	± .25
S [8]		G	.250	+ .010	6.35	+ .25
				– .005		– .12
		H	1.750	± .010	44.45	± .25
		J	3.750	± .010	95.25	± .25
		K	1.625	± .020	41.28	± .51
J6	LED	L	.143		3.63
		M	.753		19.13
		N	.165	[7]	4.19	[7]
		P	.405		10.29
P [5]
		R	2.265		52.53
	R	S	2.350		59.69

Figure 6. Mounting configuration dimensions