4. Installation
This Section provides further details regarding installation of the IPS unit.
4.1. Power Supply Connection
Connect the IPS unit to an appropriate power supply. Note that the IPS’s Main Power switch must be "On" in order for the unit to operate.
CAUTIONS:
•Before attempting to install this unit, please review the warnings and cautions listed at the front of the user's guide.
•This device should only be operated with the type of power source indicated on the instrument nameplate. If you are not sure of the type of power service available, please contact your local power company.
•Reliable earthing (grounding) of this unit must be maintained. Particular attention should be given to supply connections when connecting to power strips, rather than directly to the branch circuit.
4.1.1.Installing the Cable Keepers
The IPS includes cable keepers, which are designed to prevent the power supply cables from being accidentally disconnected from the unit.
•
•
1.First make certain that both of the IPS's two power cables are disconnected from the power source.
2.Use the screws supplied with the cable keeper kit to attach the bottom plate to the underside of the IPS unit as shown in Figure 4.1. When properly attached, the bottom plate will protrude about one inch beyond the edge of the IPS unit.
3.Use the screws supplied with the cable keeper kit to loosely attach the slider plate to the bottom plate as shown in Figure 4.1. Make certain that the slider plate moves freely, ensuring that it can be easily moved into position once the power cables are in place.